E92 330i Misfire, Cylinder 2
Discussion
Still getting issues with misfire cylinder 2.
Have replaced 6 coils, 6 plugs and 6 injectors.
Have replaced the lambda sensors and had the software updates to the newest version yet ill still get it misfire under load at 3k RPM.
Any ideas? Im going to be checking the wiring tonight for the ignition coil
Have replaced 6 coils, 6 plugs and 6 injectors.
Have replaced the lambda sensors and had the software updates to the newest version yet ill still get it misfire under load at 3k RPM.
Any ideas? Im going to be checking the wiring tonight for the ignition coil
Just a thought, but when I got a misfire on my 325ti (M54 engine) and the EML lit up my local BMW specialist diagnosed it as a H(ydraulic) V(alve) A(ctuator) issue (so a dodgy hydraulic tappet in old-speak)! I had done a few short stop/start trips in the days leading up to it, followed by a good long run of 200 miles during which it ran fine and the EML went out.
Hope you get it sorted!
Hope you get it sorted!
helix402 said:
One more idea, I have seen one BMW where there was still a misfire despite a new coil, the output stage to one coil in the DME had failed.
I had seen that. Weirdly enough the last 2 days since i posted this, the car has been behaving fine. Since i put the new O2 sensor in that looked as if it had had its day. Im getting no hesitation, no misfire, pulls strong, mpg is brilliant.
I think i may of got to the bottom of this.
Fingers crossed! Just had a new set of injectors myself. Wonder how long they last these days? I did consider running with the engine cover off to try and help airflow as they get very hot. Noting the n55 has specific coolant passages to keep the injectors cool (they are a different type of injector to n53 anyway).
Gassing Station | BMW General | Top of Page | What's New | My Stuff


