E87 1 series ABS sensors
E87 1 series ABS sensors
Author
Discussion

R500MATT

Original Poster:

12 posts

182 months

Friday 16th September 2016
quotequote all
Getting fed up of changing these, both sides changed every 6 months, think it's just crap getting flicked up from the roads and the sensor being too close to the drive shaft. Was thinking about putting a washer underneath the sensor and bolt to increase the gap but may cause the sensor not to pick up.

JakeT

6,002 posts

151 months

Friday 16th September 2016
quotequote all
Can you not just clean them? My 3 series has needed them cleaning before, and the original sensors in the car have been fine.

R500MATT

Original Poster:

12 posts

182 months

Friday 16th September 2016
quotequote all
I've tested them with a multimeter and there knackered, may try cleaning the pick up ring on the drive shafts though they do have surface rust

Craikeybaby

12,179 posts

256 months

Friday 16th September 2016
quotequote all
Is this something I've got to look forward to on mine? How do you know when they've failed? Brake warning light?

Elliot2000

786 posts

207 months

Friday 16th September 2016
quotequote all
You normally find corrosion under the reluctant ring on the drive shaft - causes the reluctant ring to bulge out slightly and then starts coming into contact with the sensor face. As u mentioned- a washer will prob sort it, otherwise new driveshafts!

R500MATT

Original Poster:

12 posts

182 months

Friday 16th September 2016
quotequote all
A couple of washers sounds like the better opinion than driveshafts, I watched a video on YouTube how to test abs sensors
http://youtu.be/7eCJa7JZzfg If the current continues to climb the sensors knackered