Discussion
Morning,
I've got a 14 plate F31 3 series, When i got in it last night I noticed the MAX AC button wasn't working, does this stop working below a certain temp or is it a fault it was -2 when i tried it.
If it is a fault would this be covered under warranty?
Edit to add. looks like it is not a fault just won't work below 0c
I've got a 14 plate F31 3 series, When i got in it last night I noticed the MAX AC button wasn't working, does this stop working below a certain temp or is it a fault it was -2 when i tried it.
If it is a fault would this be covered under warranty?
Edit to add. looks like it is not a fault just won't work below 0c
Edited by gdcts on Friday 25th November 08:31
There's a sensor on or near the evaporator core inside the HVAC module. It's job is to feedback the core temp to the control module to prevent icing - ergo, if it's too cold it will prevent Max AC from enabling. The logic is usually sound, as most people will never need (or want) to cool an already cold car.
It's more than that, the incoming air is already way below the optimal evaporator temp (the bit that does the active cooling of cabin air in the system), so actually driving the compressor/chiller system in the aircon system would only result in internal icing-up: inefficiency, energy waste, unhappiness.
Typically car aircon systems don't engage the compressor much below c.8degC external temps, ever.
This limitation is normal. Fortunately, if the external air temp is < 8degC (nevermind -2degC), the dew-point is already way lower and condensation isn't going to happen - esp. since your cabin temperature set-point is probably quite high, say 20degC or so. This last point effectively, completely and utterly dries-out the incoming cabin air - because relative humidity also depends greatly on temperature. So - without the a/c compressor running, but say >>10degC between a low external temp and the cabin set-point, by simply heating it the cabin air is made more than 'dry' enough, as you want for elimination of condensation.
Read-up on the Psychrometric chart for more than you ever wanted to know!
HTH.
ETA:
The corollary is, it takes heater-matrix-delivered engine heat to drive-out condensation on a cold morning, which may take time to deliver. This too is unavoidable; to do it with electric heating quicker from turn-on would require gobs of power, several kilowatts, such that even EVs with their huge batteries could not spare.
Typically car aircon systems don't engage the compressor much below c.8degC external temps, ever.
This limitation is normal. Fortunately, if the external air temp is < 8degC (nevermind -2degC), the dew-point is already way lower and condensation isn't going to happen - esp. since your cabin temperature set-point is probably quite high, say 20degC or so. This last point effectively, completely and utterly dries-out the incoming cabin air - because relative humidity also depends greatly on temperature. So - without the a/c compressor running, but say >>10degC between a low external temp and the cabin set-point, by simply heating it the cabin air is made more than 'dry' enough, as you want for elimination of condensation.
Read-up on the Psychrometric chart for more than you ever wanted to know!
HTH.
ETA:
The corollary is, it takes heater-matrix-delivered engine heat to drive-out condensation on a cold morning, which may take time to deliver. This too is unavoidable; to do it with electric heating quicker from turn-on would require gobs of power, several kilowatts, such that even EVs with their huge batteries could not spare.
Edited by Huff on Friday 25th November 23:41
Gassing Station | BMW General | Top of Page | What's New | My Stuff


