E60 RPA stuck on 'initialising'
E60 RPA stuck on 'initialising'
Author
Discussion

B.J.W

Original Poster:

5,877 posts

246 months

Friday 16th December 2016
quotequote all
hi, some advice would be appreciated.....

BMW E60 545i - tyres are Yokohoma Run Flats. Puncture warning light came on this morning. Checked pressure on all tyres and front o/s was low. Inflated back to 2.1 bar, equalised all 4 corners and re-set via I-drive. I know that the initialising can take some time to sort itself out and become active, but nothing is happening. The system seems to be stuck in 'initialising' and I have driven for over 30 minutes. Tried resetting a few times but the same thing happens. I'll check pressures manually again tomorrow in case I have a slow puncture, but does anyone have any suggestions as to why the RPA will not become active? Thanks in advance....

trickywoo

14,280 posts

261 months

Saturday 17th December 2016
quotequote all
How long did you wait before driving off after the reset?

Try again after being parked overnight. If that doesn't work maybe a duff abs sensor.