My E38 740iL Manual project.
My E38 740iL Manual project.
Author
Discussion

Fluffyhead69

Original Poster:

23 posts

160 months

Monday 2nd January 2017
quotequote all
Morning all.

Long time lurker here and rarely post. Thought it was about time I made a thread about my E38 7er and get some opinions on it and share what I have done in the short time I have had it.

So first of all the car is a 1998 facelift E38 740iL in Orient blue. Bought from a friend with a few issues as he didn't have the time or motivation to fix it and went out and bought himself a Jag S type R. While my friend owned the car it had a leaking fuel tank which took it off the road for some time which is a common issue with these cars. He found a replacement and fitted it... Only to find out the seller had lied to him and it also had a small pin hole leak in the seam. So anything over 50% full and it would drip.

So he has enough of it and i buy the car off him fairly cheap. Now at the time it had the fuel tank issue and also had an issue with the gearbox slipping between gears. But the car was cheap enough and I knew it had potential.

First to be done was the fuel tank as the smell of petrol was ridiculous while driving round, Plus a 2 tonne car with a 4.4 V8 doesn't need anything else to make consumption worse.

Next we looked at the auto gearbox and notices it was weeping oil very slightly and was low on oil at the time so we just topped it up and it was back to perfect again. So the car was driving spot on. Couple of months go by and I decide to get the gearbox sorted properly, So bought the recommended gearbox oil and filter and had it changed. within 50ft of driving it was slipping again. Turns out on old worn boxes clutch particles can become lodged in the intricate parts of the box and cause issues when old oil is taken out and that's likely what caused my issues (or so I am told).

After being quoted £1700 for a rebuild with only 12 months warranty I decided it was time to do something different and go for a manual box. I know a lot of people say that a big cruiser of a car shouldn't have a manual box but I enjoy driving a manual. I sourced a 6 speed manual gearbox from an E39 M5 which would go right on and also while I was there decided to swap out the 2.98 open diff and get get the 3.15 M5 LSD and have that fitted too. While getting parts together more and more things kept popping up I liked the sound of so the parts list was getting longer. I got myself a bargain set of E38 Brembo 4 pot calipers that had been fully rebuilt using all new pistons and seals and been powder coated in red with new Brembo stickers on. To go with that I got new grooved discs and Ferodo pads plus some custom made HEL braided brake lines. New lower control arms also found there way onto the list after seeing mine had seen better days. Plus a new Radiator, water pump and heater control valves. Also while it was being worked on I figure i may as well try get a bit more power out of it and get myself an inlet manifold off an M60 motor (pre vanos) which I had fitted with all new gaskets and had the engine remapped to suit it.

So the build itself didn't exactly go to plan but wasnt too bad considering how much was being done. Firstly I couldn't find anybody that had put an M5 LSD into an E38 so had little to no information to make it work. I was told that the cups off the M5 driveshafts should match the 7 series driveshafts meaning I can make a set of driveshafts that will work as the M5 ones wont be long enough on there own. This was incorrect. I did however find out that the Diff used 102mm shafts and it just so happens that early model 750i use the same ones, Only problem is they are hard to find. After a day of calling every BMW breaker I could find in the UK i found some over in Ireland so these were sent straight over and turned out to be exactly what I needed. Also I had been told that the M5 flywheel I had with my gearbox would work just fine. Turns out it isn't... So i ordered a replacement M62 flywheel.... and get another M5 one. Then that had to go back and eventually after over a week of messing about get the correct M62 flywheel. Then to top it off, once everything was pieced back together and taken for a test drive. The diff lasted 10 mins before seizing up and wouldn't move more than 1 rotation.
So that was £600 down the drain for that and I had to go and find another which fortunately came up fairly quickly. Once fresh oil was in it it was back out to test and this one was fine.

Finally after the car being off the road for 5 months it was done! I have had it on the road for about a week now and gotta say I love it. Feels much more responsive than before and certainly gets down the road well. Its not as relaxing and easy to drive as it was when it was auto but i never expected it to be. There is still a lot more planned for this year. Mainly Paint and interior tidying up and some better coilovers. But overall I love it. It drives well, Sounds incredible (back boxes are gone for quad pipes) and is still the big cruiser it was always meant to be.


Higgs boson

1,105 posts

184 months

Monday 2nd January 2017
quotequote all
Congratulations, and very well done.
You displayed some resolve, there. clap

Rsdop

458 posts

148 months

Monday 2nd January 2017
quotequote all
Very nice work! Would love an E38 with a big engine but always put off by the auto gearbox.

Fluffyhead69

Original Poster:

23 posts

160 months

Monday 2nd January 2017
quotequote all
Higgs boson said:
Congratulations, and very well done.
You displayed some resolve, there. clap
Cheers pal. I am not gonna lie it got advertised for sale a couple of times then taken off as i couldn't bear to sell it haha. Very glad I didn't. It gets a lot of positive attention.

Helicopter123

8,831 posts

187 months

Monday 2nd January 2017
quotequote all
Nice project - has the car already been lowered?

Fluffyhead69

Original Poster:

23 posts

160 months

Monday 2nd January 2017
quotequote all
Yeah it already had coilovers on when I bought it so is sat a fair bit lower than standard. They are showing there age now so in a little while I'm gonna be in the market for something else. Maybe go for BC coilovers as they seem highly recommended.