Fitting an e36 m tec 2 steering wheel to a e46.
Fitting an e36 m tec 2 steering wheel to a e46.
Author
Discussion

Swede123

Original Poster:

630 posts

223 months

Friday 1st September 2017
quotequote all
Has anybody done this ? I want to get a smaller diameter wheel and do away with the airbag.

4rephill

5,171 posts

209 months

Saturday 2nd September 2017
quotequote all
Removing the airbag steering wheel and fitting a non-airbag steering wheel to the car "should" be an MOT fail under section 5.4 of the MOT inspection Manual which states:

5.4 Supplementary Restraint Systems (SRS)

1) As far as is reasonably practicable, check that all airbags fitted as original equipment are present and not obviously defective.

Reason for rejection:
An airbag obviously missing or defective.

You should also fall foul on the rules concerning the Airbag warning light either not illuminating at all, or remaining on.

(There are exceptions for modified cars, such as cars that have been modified into rally cars, but your car will not fall into that category)

Chances are I suspect, you don't give a scensoredt about any of that though! wink

BGarside

1,568 posts

168 months

Saturday 2nd September 2017
quotequote all
Got the same problem with my E36 328i - the airbag wheel feels too big. Had the Mtec 2 'wheel on my previous 325 and much preferred it. Is there a Sport model in the range with a smaller airbag wheel you could fit?

pvogue

902 posts

145 months

Saturday 2nd September 2017
quotequote all
I had the E46 M3 CSL wheel on my old E36 back in days. I would get that instead, I think its slightly smaller and feels better. Removed air bag with just the airbag cover on, although airbag light was on had ti put a resistor in to turn it off or something to that extent this was back in 03!

SebringMan

1,774 posts

217 months

Sunday 3rd September 2017
quotequote all
If an E46 M3 wheels is the same size as a CSL wheel they are about £100+ secondhand still which may put that idea to rest...