E91 Headlight Washers...
Discussion
Went to my car this morning and in place of the pop up headlight washers is 2 big holes !
Assumed they had been stolen so phoned dealer to ask about replacements, surprised when they told me that they may not have been stolen as they have had quite a few go missing over recent weeks, apparently the pipes are freezing and when you use them they are popping up and out !
So it appears it's a design fault, when you need them most they fail and to top it off the replacements supplied painted and fitted are £240 with no guarantee it won't happen again
Anyone else heard of this, either them beign stolen or falling out, not happy !
Assumed they had been stolen so phoned dealer to ask about replacements, surprised when they told me that they may not have been stolen as they have had quite a few go missing over recent weeks, apparently the pipes are freezing and when you use them they are popping up and out !
So it appears it's a design fault, when you need them most they fail and to top it off the replacements supplied painted and fitted are £240 with no guarantee it won't happen again
Anyone else heard of this, either them beign stolen or falling out, not happy !
Yes happened to me also last week on an 06 e92 and is happening on a lot of other models in fact there is an earlier thread on a previous page.
They do not have to be used for them to pop out as mine was parked outside for a week and after the snow had melted off the car noticed both of them hanging out.
The water is freezing inside the pipes and pushing them out, a design fault if there ever was one and this is happening worldwide but BMW will not take responsibility and say its wear and tear.
I was lucky as mine did not fall off however one of them is not retracting 100% and standing out a bit however there is no way I shall fix it as the one they replace is the exact same so they have not modded the part even though this is a design fault.
They do not have to be used for them to pop out as mine was parked outside for a week and after the snow had melted off the car noticed both of them hanging out.
The water is freezing inside the pipes and pushing them out, a design fault if there ever was one and this is happening worldwide but BMW will not take responsibility and say its wear and tear.
I was lucky as mine did not fall off however one of them is not retracting 100% and standing out a bit however there is no way I shall fix it as the one they replace is the exact same so they have not modded the part even though this is a design fault.
Gassing Station | BMW General | Top of Page | What's New | My Stuff


