Stop my fairings melting
Stop my fairings melting
Author
Discussion

moanthebairns

Original Poster:

19,183 posts

229 months

Wednesday 8th March 2017
quotequote all
Relatively boring and straight forward topic.

I have fitted an aftermarket manifold to the bike as Kawasaki wanted £800 for a oem one.

It sits slightly closer to the fairing, and has started to melt the inside lip of the fairing slightly.

Any tips, i thought about putting a few washers at the mounts bringing out the effected fairing away from the exhaust, although This is probably a st idea.

I was going to apply heat shield tape on the inside face of the fairing or do I wrap the offending area of the pipe.

SystemParanoia

14,343 posts

229 months

Wednesday 8th March 2017
quotequote all
do both smile

Chongwong

1,045 posts

178 months

Wednesday 8th March 2017
quotequote all
Be careful if you are using heat shield tape, some of it isn't meant for temps higher than 70 or 80 degrees Celsius. It would probably be alright on the inside edge of the fairing, but i'd assume that some proper heat shield webbing wrapped around the pipes would be more effective.

Rubin215

4,201 posts

187 months

Wednesday 8th March 2017
quotequote all
Let it melt the lip of the fairing until it is the shape it needs to be then use a stanley knife to trim the melted bit to a nice edge.

Knowing you're a Bairns supporter, I'm fairly sure you will be able to handle a stanley knife...

Moulder

1,648 posts

243 months

Wednesday 8th March 2017
quotequote all
I have never found exhaust wrap particularly effective. It also sounds like there isn't much space to get a few thick layers on without getting close to the bodywork, so I'd go for heat shield.

If you street fightered it the problem would go away...