Moulded ear plugs
Author
Discussion

Ki3r

Original Poster:

8,922 posts

190 months

Monday 10th April 2017
quotequote all
Can anyone recommend anywhere to get some moulded ear plugs? I don't get on with the foam ones and can never get them in right.

Budget of around £100, and down in Dorset if anyone can recommend anywhere heresmile.

Andybow

1,177 posts

149 months

Monday 10th April 2017
quotequote all
Ki3r said:
Can anyone recommend anywhere to get some moulded ear plugs? I don't get on with the foam ones and can never get them in right.

Budget of around £100, and down in Dorset if anyone can recommend anywhere heresmile.
I got some done a few years ago just by a local hearing place, I'm in east Devon ,they are well worth having, I got speakers in mine so added benefit is I've got a custom set of headphones as well, they will do normal ones for under £100 if I can remember

RemaL

25,103 posts

265 months

Tuesday 11th April 2017
quotequote all
I have Ultimate ear plugs and they are good but do not remove the level of noise a foam plug does.

My Ultimate ear plugs are great for all day. easy to use and wear all day but unless I'm out all day I will use foam plugs

ANd maybe try different pugs as I found I get on with some and not others

Super Slo Mo

5,374 posts

229 months

Tuesday 11th April 2017
quotequote all
I have Ultimate Ear ones too. They are very good but don't seal properly unless I use ear comfort gel or similar to aid their fitting.
If I don't, they let some high frequency wind noise past which annoys me and leaves my ears ringing.
They were a lot less than £100 although I had the discounted deal at the bike show a couple of years back.

ianrb

1,644 posts

171 months

Tuesday 11th April 2017
quotequote all
If you struggle to put standard foam plugs in your ears I don't think getting custom moulded ones will solve the problem; they still need to go into your ears correctly. I think your best bet would be to figure out how to insert the plugs first & then look as custom moulds later.
For what it's worth the procedure I use is: Roll plug until it's small enough, use left hand to pull right ear upwards slightly then use right hand to put plug in ear.

E36GUY

5,907 posts

249 months

Tuesday 11th April 2017
quotequote all
I've just bought some titanium plugs from Flare Audio. Expensive at £50 but bloody good. (cheaper if you get the aluminium ones)

cpl_payne

576 posts

214 months

Tuesday 11th April 2017
quotequote all
E36GUY said:
I've just bought some titanium plugs from Flare Audio. Expensive at £50 but bloody good. (cheaper if you get the aluminium ones)
And I have the exact opposite experience with Flare Audio as regular foam ones beat these into a cocked hat. I've even tried putting Flare into one ear and foam into another for comparison and there's no doubt - I prefer foam. Far more comfortable and quieter than the fancy pants ones.

Wacky Racer

41,424 posts

278 months

Tuesday 11th April 2017
quotequote all
Have you tried mouldable swimming ones, Zoggs/Beco etc, 2 prs in a pack for £4.00, available in any decent sports shop?.

Knead 'em in your fingers like putty to fit.

You can use them over and over again.

Certainly worth a try.

K12beano

20,854 posts

306 months

Tuesday 11th April 2017
quotequote all
Personally, I'm OK with the foam ones......
Wacky Racer said:
Have you tried mouldable swimming ones, Zoggs/Beco etc, 2 prs in a pack for £4.00, available in any decent sports shop?.
.....but this must be something to try first.


Best thing about this page was the juxtaposition with this relevant advert:



E36GUY

5,907 posts

249 months

Tuesday 11th April 2017
quotequote all
cpl_payne said:
And I have the exact opposite experience with Flare Audio as regular foam ones beat these into a cocked hat. I've even tried putting Flare into one ear and foam into another for comparison and there's no doubt - I prefer foam. Far more comfortable and quieter than the fancy pants ones.
I like that the Flare ones are less invasive than the foams. I'd had issues with blocked ears recently probably from using the foam ones pushed in too far.

Speed addicted

6,336 posts

258 months

Tuesday 11th April 2017
quotequote all
Quite a few of the places for earplugs will sell you an assorted box of the foam ones. That way you can try them and see which ones work best for you.
use the howard leight ones
https://www.amazon.co.uk/d/gh3/40-Laser-Lite-Ear-P...


cpl_payne

576 posts

214 months

Tuesday 11th April 2017
quotequote all
E36GUY said:
cpl_payne said:
And I have the exact opposite experience with Flare Audio as regular foam ones beat these into a cocked hat. I've even tried putting Flare into one ear and foam into another for comparison and there's no doubt - I prefer foam. Far more comfortable and quieter than the fancy pants ones.
I like that the Flare ones are less invasive than the foams. I'd had issues with blocked ears recently probably from using the foam ones pushed in too far.
Interesting, I find Flare more invasive. People have different ear canal shapes and sizes, so there's probably quite a lot of variation there. With foam ones I usually use simple cone shaped ones (Moldex 7800 Spark Plugs). When rolled properly I can fit them into the ear canal almost fully, with only a couple of mm sticking out which makes them easier to remove. The flared ones (like Laser Lite linked to below) are even easier to remove as they leave more material sticking out. I never have my ears syringed, I suppose that's also quite individual as some people get ears so blocked they get infections and have issues hearing. When I went for a long trip where I wore earplugs daily for over 10 days I did clean my ear canals with a fluid, but regular olive oil works just as well - just add a couple of drops into the ear, lay on the opposite side for a couple of minutes to give it some time to work and rinse out in the shower or tap with warm water - clean as a whistle and no wax deposits on earplugs.

Anyway, so the metal Flare ones don't actually go all the way into the canal, I don't believe they're designed to. I've tried all 3 supplied foam end sizes, the bigger ones don't even fit and the smaller ones still don't form a good enough seal to prevent a lot of noise. The metal parts stick out - while that's easier to remove it just feels uncomfortable and louder than foam ones. A month or so after Flare came out they released a new version called Flare Mini - I didn't want to spend more money but it could be that these actually work better.

dibblecorse

7,668 posts

223 months

Tuesday 11th April 2017
quotequote all
Hi

Go look at Mercury Hearing and see whether they are attending a show or event anywhere near you in the near future, the regularly appear at equestrian shows, bikes shows and other events up and down the country and are excellent.

http://www.mercuryhearing.com/

casbar

1,152 posts

246 months

Tuesday 11th April 2017
quotequote all
Try pinlock ear plugs, they come with two different sizes. Have been using them for about 5 years and they are very good and comfortable. I prefer them to foam.

gareth h

4,334 posts

261 months

Tuesday 11th April 2017
quotequote all
The problem I find with the moulded ear plugs is that the shape of the ear seems to change when I pull a helmet on, they work great under a beanie in the caterham, but are a bit rubbish on the bike where foam seems to work best.

mckeann

2,996 posts

260 months

Tuesday 11th April 2017
quotequote all
my ear canal shape changes when i go from upright to tucked in behind screen and lets lots of wind noise in.

Learn how to fit the foam ones and save your money

to fit the foam ones, roll them up very tight (wetting your ear can help insertion, as can pulling your ear up and back) then slip it in quickly before it has a chance to expand. They need to go in until they're almost flush fitting. When looking in a mirror, you shouldnt be able to see them

Biker's Nemesis

41,487 posts

239 months

Tuesday 11th April 2017
quotequote all
mckeann said:
slip it in quickly before it has a chance to expand.
That's all I saw in your reply Neil.

Ya pervert.

bogie

17,108 posts

303 months

Tuesday 11th April 2017
quotequote all
I got the DIY kit for custom ones a few years back, they do work, but I could not be bothered with the faff of having something else to clean every few rides. After a couple of ear infections that took weeks of anti biotics to get rid of, I went back to foam disposables.

Try a few different brands of foam, learn how to insert them properly and they are as good as anything - unless you want moulded with built in earphones or something......

Farlig

633 posts

183 months

Tuesday 11th April 2017
quotequote all
This
gareth h said:
......the shape of the ear seems to change when I pull a helmet on.....
And this
mckeann said:
my ear canal shape changes when i go from upright to tucked in behind screen and lets lots of wind noise in.
And especially this
mckeann said:
Learn how to fit the foam ones and save your money
There are loads of different styles of foam plugs in as many different sizes - buy a variety bag and keep trying. When you find the right type & learn to fit them properly, you will be rewarded with a far superior noise reduction and lasting fit under the changing conditions inside a bike lid...


DanGPR

991 posts

202 months

Tuesday 11th April 2017
quotequote all
Try some Howard Leight Laser Lite earplugs, I have small ear canals and often struggle with earplugs/in ear headphones. These are very soft and malleable but expand quickly to really fill your ear'oles

HERE