Suzuki SV650 2017 - Lowering
Discussion
My other half sat on one yesterday and it's much lower than the previous model (785mm now) and is a lovely looking bike. She's v short so would still need it lowered another 2 to 3" to be comfortable (on tip, tip toes). She prefers sports bikes to custom bikes but is stuck here due to their lower seat heights (680mm +\-).
Anyone had any experiences, either seat mods, suspension lowering kits or.....?
Thanks
Chris
Anyone had any experiences, either seat mods, suspension lowering kits or.....?
Thanks
Chris
You can lower a bike by 2-3" but where is your ground clearance going to be? you'll be decking the pegs out at moderate lean angles, lowering kits work and usually just consist of longer dog bones in the rear linkage, combined with raising the forks in the yoke, but you are altering the geometry by doing this and the bike may end up very unstable as you a shortening the steering angle considerably.
Best bet is a modified seat and platform boots!
Best bet is a modified seat and platform boots!
Agreed on all points but she's not a fast rider so ground clearance is not the main issue. I'd be more concerned if the handling would be b*ggered.
As she's small and light(<60kg) I know one can play with the suspension damping / rebound etc.
I'm talking with the main dealer next week who has some ideas to discuss. (Seat / suspension and some mods)
As she's small and light(<60kg) I know one can play with the suspension damping / rebound etc.
I'm talking with the main dealer next week who has some ideas to discuss. (Seat / suspension and some mods)
Lowering a bike also lowers its centre of gravity, so you don't need to lean it as far in corners. To a degree.
It also means side and centre stands need modifying too. Bear in mind your warranty might not be too valid if you make a bunch of changes to the bike, you know how they get when you want something fixed....
A cut down seat or custom seat might be the easiest way to get her feet on the ground.
I fitted a lowering kit to my Bandit 1200 and the seat height dropped best part of 1 1/2"
Side stand is still usable, just. Centre stand takes some muscle to get it up and on.
It also means side and centre stands need modifying too. Bear in mind your warranty might not be too valid if you make a bunch of changes to the bike, you know how they get when you want something fixed....
A cut down seat or custom seat might be the easiest way to get her feet on the ground.
I fitted a lowering kit to my Bandit 1200 and the seat height dropped best part of 1 1/2"
Side stand is still usable, just. Centre stand takes some muscle to get it up and on.
Thanks Giby, this is the sort of info we want.
She also looked at the new Honda CA500 (Rebel) and Yamaha SV(?) 950 and both were perfect with low seats and importantly she could reach the foot controls but she prefers the naked sport bike look. I saw this link www.metisse.de which is interesting.
She also looked at the new Honda CA500 (Rebel) and Yamaha SV(?) 950 and both were perfect with low seats and importantly she could reach the foot controls but she prefers the naked sport bike look. I saw this link www.metisse.de which is interesting.
King Herald said:
Lowering a bike also lowers its centre of gravity, so you don't need to lean it as far in corners. To a degree.
COG makes negligible difference to lean angle in practical termS. At the extremes a bike with a higher COG will actually lean slightly less than a bike with a lower COG, the difference being dependent on the width of the tyres (wider tyres=more lean required).Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


