Timing on Chinese 110cc problem ?
Discussion
I know it's chinese ......
Lifan 110 engine.
The "crank" pully has t and f marked on it. The cam has a dot mark on it.
If I try to line up the "t" the crank pulley won't stay put, it slips backwards. If I i hold it in place then the dot on the cam lines up fine. If I let go it slips backwards a touch.
If I rotate the crank pulley 360 degrees the "t" will stay in position without moving at all, but the cam mark is 180degrees out ?
what has gone wrong here - does it actually matter ? The bike runs fine.
When setting valve clearance, can I lock the crank in the t position with a screwdriver- making sure the cam sprocket lines up ?
Thanks
Del
Lifan 110 engine.
The "crank" pully has t and f marked on it. The cam has a dot mark on it.
If I try to line up the "t" the crank pulley won't stay put, it slips backwards. If I i hold it in place then the dot on the cam lines up fine. If I let go it slips backwards a touch.
If I rotate the crank pulley 360 degrees the "t" will stay in position without moving at all, but the cam mark is 180degrees out ?
what has gone wrong here - does it actually matter ? The bike runs fine.
When setting valve clearance, can I lock the crank in the t position with a screwdriver- making sure the cam sprocket lines up ?
Thanks
Del
How are the clearances adjusted - If it's lock nut and screw type then as long as it's 'off cam' the clearance should be easy to set; no need to pull it to bits. If it's shim and bucket type make your own temporary marks and as long as it goes back together in the same place you'll not upset the timing - If you have to remove the cams and the cam chain tensioner is a ratchet type make sure you know how to reset it before you start - goes off to Google Lifan 110cc engine just for SnG's....
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


