Wiring replacement indicator?
Wiring replacement indicator?
Author
Discussion

Spanglepants

Original Poster:

1,743 posts

168 months

Tuesday 4th July 2017
quotequote all
Bought an indicator off eBay but the wiring is different. The new one comes with 3 wires - black, red and black/ white and bullet connectors whereas he original has just a green and black/ yellow with a different connector.
Any ideas how to get this to work, bearing in mind I'm crap at anything electrical
Cheers

graham22

3,328 posts

236 months

Tuesday 4th July 2017
quotequote all
Can't think why any normal indicator would have 3 wires.

Could it be one with a sidelight bulb/element in it? Like US bikes of old and some new Hondas?

trickywoo

14,283 posts

261 months

Tuesday 4th July 2017
quotequote all
Although this link shows them as unavailable you can easily find similar. https://www.amazon.co.uk/Waterproof-Solder-Shrink-...

Massively easier than trying to solder with an iron. The red ones are what you want for indicators.

All indicators I've seen have only had two wires so no idea what three is about.

Speed addicted

6,336 posts

258 months

Tuesday 4th July 2017
quotequote all
Connect it up and see?
As previousl said it could be for US bikes that have them on all the time.

Also agree about the heat shrink solder things, wish I'd found them years ago.

graham22

3,328 posts

236 months

Tuesday 4th July 2017
quotequote all
graham22 said:
Can't think why any normal indicator would have 3 wires.

Could it be one with a sidelight bulb/element in it? Like US bikes of old and some new Hondas?
Should have said earlier:

Take the lens off and have a look at the bulb, if it has 2 filaments like a brake/tail light then it is a sidelight/indicator combo.

While there see what wire is acting as earth (it will be attached to the body of the bulb holder). Trace that wire back to the plug & attach it to the negative of a/your battery (hold it/crocodile clip) then touch either of the other wires, which ever gives the brightest light is the one to use.

Assuming your old indicator is still to hand, cut the plug off of that & solder to the above wires having established which wire is earth and which one is the live feed.

Spanglepants

Original Poster:

1,743 posts

168 months

Wednesday 5th July 2017
quotequote all
Thanks everyone, after some tinkering about with it I'm returning it and ordering a genuine one from Kawasaki .
Also realised the stalk on it was a bit shorter than the originals.