New ignition switch not working?
New ignition switch not working?
Author
Discussion

robbocop33

Original Poster:

1,207 posts

138 months

Wednesday 9th August 2017
quotequote all
This is an odd one. I have never had any problem on the rare occasion i've bought Chinese Ebay specials.
But just bought a new ignition swith/barrel for my bike. First problem was no ignition lights on dash at all, wiggled wires, hey presto,lights, but bike wouldn't fire? Bared back outer loom cover, three wires were cleanly cut through!!! Soldered these now i'm getting dash lighting up everytime, but nothing when i hit the starter, now here's the odd thing.
I refitted old ignition(which fires bike up but key bugger to turn) and checked with a test light which wires in the harness plug were illuminating when ignition was turned on, then i fitted Chinese one, all the same wires lit up my test lamp?? What gives?
The barrel and key turn feels spot on.


Edited by robbocop33 on Wednesday 9th August 16:07

Biker's Nemesis

41,487 posts

239 months

Wednesday 9th August 2017
quotequote all
Pour a little bit of engine oil down the barrel of the old switch and throw the new one away.


Jazoli

9,707 posts

281 months

Wednesday 9th August 2017
quotequote all
^^^^

failing that buy an OEM one, I had issues with chinese switches on my little YBR, they are st and incorrectly wired.

robbocop33

Original Poster:

1,207 posts

138 months

Wednesday 9th August 2017
quotequote all
Biker's Nemesis said:
Pour a little bit of engine oil down the barrel of the old switch and throw the new one away.
I actually had the graphite powder down it my key cutting guy recommended. Plus i took old barrel down to him today asking if cutting new key would make it better, he said no, if key doesn't turn most of the time, barrel is knackered!
Interesting someone mentioned them being wired wrong, read someone else say that online, also someone else mentioning putting a 100 ohm resistor somewhere?
Chinese barrel part of ignition feels great, wouldn't like to dump it if maybe some wires are in the wrong order.