Cheap but functional heated grips and gear indicator
Discussion
jamiebae said:
I'm looking for both of the above, and possibly some hand guards too. Does anyone have some recommendations or advice of what to avoid?
Thanks
Not sure what you define as cheap but the Oxford heated grips are excellent, probably one of the only things they make that I would recommend. I have a gear indicator on mine that was fitted by the previous owner, its just a cheap ebay one but does the job, its a very simple mechanism using magnets.Thanks
Oxford heated grips are bloody hot, I have some on my Versys and they are great.
I also used R&G ones on previous bikes, they are also ok but not as hot (in my experience)
you can buy cheap gear indicators off ebay for £15 but they require a lot of messing around, better ones are around £50 that are plug and play (usually into the diagnostics plug)
I also used R&G ones on previous bikes, they are also ok but not as hot (in my experience)
you can buy cheap gear indicators off ebay for £15 but they require a lot of messing around, better ones are around £50 that are plug and play (usually into the diagnostics plug)
Thanks, I'm just about to order the Oxford grips. I need to go for the 692 which are listed as the 'Sportsbike' version as the Adventure ones are too long even with the maximum chopped off which I assume will be fine as the closest my bike gets to actual adventure is hopping up a curb to park on the pavement.
I will hold fire on the gear indicator I think, if I decide I need one then I'll go for the diagnostic port version rather than having to route cables down to the shifter.
I will hold fire on the gear indicator I think, if I decide I need one then I'll go for the diagnostic port version rather than having to route cables down to the shifter.
I use Oxford heated grips touring. Cheapest place I found them was with an Oxford dealer in Poland on eBay. Very easy to install, the hardest part is choosing an appropriate path to route the wires to the battery.
It has an intelligent controller than will sense when the bike is off and cut battery draw.
It has an intelligent controller than will sense when the bike is off and cut battery draw.
jamiebae said:
I've actually looked at a couple of bikes where the grip just spins (one was an Oxford one). Any tips to stop this happening?
I wrapped my throttle tube / bar in electrical tape which increases the circumference and ensures a tight fit. Also used hairspray to help it on, dries quickly though so be quick.Nath911t said:
I've had both Oxford and R&G and both were fine.
If i were to get another set it would be the Oxfords as don't they turn themselves off unless you relay wire them to stop the power when the ignition is off?
I wired mine to the light circuit as any other alternate seemed impossible. I does the job fine though, if you stop to fill up with fuel the V8 does switch itself off which sometimes you only notice when your hands start getting cold!If i were to get another set it would be the Oxfords as don't they turn themselves off unless you relay wire them to stop the power when the ignition is off?
Also wiring to the lights stops any risk of battery flattening, they claim to sense engine off but why risk it?
Heated grips are on, it was fairly easy (although I made a bit of a mess with the glue...) . I'm not impressed with the connections though, they're not even remotely weatherproof and the cables aren't long enough to get them tucked in behind the bodywork properly so I'll have to tape them up. They work fine, turn themselves off and the controller doesn't look too bad, I might spray the mount black though.

jamiebae said:
Heated grips are on, it was fairly easy (although I made a bit of a mess with the glue...) . I'm not impressed with the connections though, they're not even remotely weatherproof and the cables aren't long enough to get them tucked in behind the bodywork properly so I'll have to tape them up. They work fine, turn themselves off and the controller doesn't look too bad, I might spray the mount black though.

Rather than spraying the mount, if you have handlebars rather than clip ons, I use these...https://www.ebay.co.uk/p/871164687?iid=12136157666...
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff



