JB Weld on engine casing?
JB Weld on engine casing?
Author
Discussion

naetype

Original Poster:

890 posts

281 months

Sunday 3rd September 2017
quotequote all
Looks as though I have a small pinhole in my Daytona 675's engine casing. It's bad enough to be spraying oil on the rear tyre but only when oil is warm and/or there's enough pressure in the casing.

I'm thinking of carefully prepping the area by first roughing it up with a steel brush and then giving it a proper cleaning down with some IPA/Brake cleaner before applying copious amounts of JB Weld with a trowel*

Damage occured when the front sprocket came off so there's no unknown internal engine malarkey going on.

Opinions and advice appreciated.



  • Not really...

Rubin215

4,201 posts

187 months

Sunday 3rd September 2017
quotequote all
I use Wurth Chemical Metal; comes as a stick with the two compounds separate; you cut a bit off, work it between your fingers for a bit to mix them and then just blob it on.

Amazing stuff; I have fixed holes in crankcases and petrol tanks, created new bearing housings and fixed countless monkey-metal children's toys with it.

MrGman

1,670 posts

237 months

Sunday 3rd September 2017
quotequote all
Is there a chance the casing could be cracked and if so the jbweld wouldn't strengthen this if a chunk of engine casing decided to let go?

I think i'd rather try and find a secondhand casing if the originals are too expensive.

mudster

792 posts

275 months

Sunday 3rd September 2017
quotequote all
If there is enough access I would get the area degreased and get it tig welded.

naetype

Original Poster:

890 posts

281 months

Sunday 3rd September 2017
quotequote all
New casing complete is coming in at ~£1500, add labour onto that and it's more than the bike's worth.

Very unlikely the casing is cracked and certainly no evidence of that. There are some gouges in the aluminium casing, clearly from the chain, but when engine is cold there's no evidence of oil seeping out so it's an educated guess that it's only a pinhole.

TIG welding would mean engine out and dismantling. Would only do this if opinions were that JB Weld or similar wouldn't fix it as once I whack the epoxy on then welding is out of the question.

Good to hear about the Wurth epoxy, that's encouraging...


Private Pile

754 posts

226 months

Sunday 3rd September 2017
quotequote all
I'd definitely try the repair. Belzona is great stuff that I've used in the past.

Xtriple129

1,173 posts

188 months

Sunday 3rd September 2017
quotequote all
I've used a variety of chemical metal products over the years to repair damaged casings on bikes - even used the stuff to repair fins on an air cooled once. Never had any problems after, just clean te area well, degrease well(er) and do a good job. Much better than £1500!

Birky_41

4,667 posts

215 months

Sunday 3rd September 2017
quotequote all
Exactly same thing just happened to me

Jb weld will hold that fine. Just prepare it properly