VFR 400 NC30 throttle issues - any thoughts?
Discussion
Evening all,
I'm having some issues with my NC30 and would welcome knowledge from the collective.
The bike starts fine, and idles ok (around 1300-1500 rpm), but there's an issue when snapping the throttle open. A quick blip from idle when warm, 'bogs' down the revs with a farting noise from the intake trumpets, before the revs rise. A delay of maybe a second.
Setting the idle artificially high (3000rpm) removes the problem, but causes the revs to fall more slowly.
So far I've checked the electrical circuit (battery, reg/reg all ok), balanced the carbs (a swine of a job), checked the carb rubbers for leaks (all ok) and changed the choke cable.
All this has taken some time, and it's still not great. My next step was to look at the carb diaphragms, then dismantle the carbs for a rebuild.
Anything glaringly obvious I've missed or suggestions to what it might be? I've considered the CDI but don't want to replace it 'just in case' as my instinct tells me it's fuelling related.
All tests conducted with an independent direct fuel supply btw.
Cheers,
Tom
I'm having some issues with my NC30 and would welcome knowledge from the collective.
The bike starts fine, and idles ok (around 1300-1500 rpm), but there's an issue when snapping the throttle open. A quick blip from idle when warm, 'bogs' down the revs with a farting noise from the intake trumpets, before the revs rise. A delay of maybe a second.
Setting the idle artificially high (3000rpm) removes the problem, but causes the revs to fall more slowly.
So far I've checked the electrical circuit (battery, reg/reg all ok), balanced the carbs (a swine of a job), checked the carb rubbers for leaks (all ok) and changed the choke cable.
All this has taken some time, and it's still not great. My next step was to look at the carb diaphragms, then dismantle the carbs for a rebuild.
Anything glaringly obvious I've missed or suggestions to what it might be? I've considered the CDI but don't want to replace it 'just in case' as my instinct tells me it's fuelling related.
All tests conducted with an independent direct fuel supply btw.
Cheers,
Tom
Start with a fresh battery and new plugs; most carb related issues aren't.
If it's still not happy, strip the carbs and make sure all the jets are completely clear; it doesn't take a lot to block them.
Fit a new inline fuel filter too.
And I take it the valves have been done within living memory?
If it's still not happy, strip the carbs and make sure all the jets are completely clear; it doesn't take a lot to block them.
Fit a new inline fuel filter too.
And I take it the valves have been done within living memory?
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


