Hot wired and flat battery
Hot wired and flat battery
Author
Discussion

del mar

Original Poster:

2,838 posts

230 months

Wednesday 27th September 2017
quotequote all
Morning,

The wires into the ignition barrel have worn, after 15 years and 99,000 miles, so the connection was a bit hit and miss

Recovery lady hot wired it so the connection is permanently on/live. I have been disconnecting the battery until I can get a new barrel, however last night I switched off all the lights and left the battery connected.

This morning it was flat - where did my electricity go ?

Thanks

cmaguire

3,589 posts

140 months

Wednesday 27th September 2017
quotequote all
Ultimately you need a new ignition barrel, problem solved, so who cares?

But without knowing the bike involved nobody can tell you anyway. Any modern fuel injected bike is likely to have a 12v supply to things like injectors etc with ignition on, whereas an old carbed bike is far less likely to have components live and causing small drains.

It doesn't take much to drain a battery overnight, some crappy old alarms can do it in a week.

del mar

Original Poster:

2,838 posts

230 months

Wednesday 27th September 2017
quotequote all
It is on order, but was wondering what went wrong.

It is a 2002 900 Diversion so no fancy electronics on that !


CaptainSlow

13,179 posts

243 months

Wednesday 27th September 2017
quotequote all
Why can't you use the kill switch?

cmaguire

3,589 posts

140 months

Wednesday 27th September 2017
quotequote all
CaptainSlow said:
Why can't you use the kill switch?
Usually ignition cut only and possibly fuel, everything else still live.

del mar

Original Poster:

2,838 posts

230 months

Tuesday 3rd October 2017
quotequote all
Whilst waiting for second hand one, I repaired it !.

Reasonable straight forward.

Remove top yoke

Unbolt entire barrel, disconnect wires.

The screws holding it together are "security" ie the head snaps off when you tighten it. Angle grind the head off and remove the internals.

You can then see where the wires have become unattached, a bit of soldering and it is all fixed !!

I now have a spare for when my soldeirng fails but it is a doable diy job.