Bike Stands/Lifts
Discussion
I pissed around for ages with paddock stands, beer crates, chains from the ceiling and all kinds of contraptions.
Then I bought a hydraulic lift/table - best thing I ever did, no more crouching, kneeling, even lying on the floor to adjust (Ducati front cylinder exhaust) valve clearances. Rather I can sit or stand in comfort and save my back/knees.
Should have bought it years earlier...

Then I bought a hydraulic lift/table - best thing I ever did, no more crouching, kneeling, even lying on the floor to adjust (Ducati front cylinder exhaust) valve clearances. Rather I can sit or stand in comfort and save my back/knees.
Should have bought it years earlier...

Chilli said:
bridgland said:
This is the one. Now, how do I know if it will fit my bike??!!That hydraulic lift is the nuts.....I wouldn't have the space though.
The Bursig ( type of lift) is a cracking piece of kit and can be used for tons of bikes with different adaptor kits.
catso said:
These things would be great if they were about a foot wide, so that you could park a bike on them when not using it for working on, but it wouldn't get in the way. My bikes are all parked close together, so that I can use the rest of the cave, I'd like a hydraulic table but I just haven't the space for a full size one.I have wondered whether one of those "rocking" stands that you sometimes see cars on outside dealers would be a good alternative. Wheel chock at the sharp end, run the bike up until the stand tips forward, job done. Could even incorporate a foldable outrigger if stability was a concern.
These things:

I wish i had bought the ABBA skylift.
I purchased the ABBA superbike package three to take the wheels off the floor, and to move it around the garage.
World's biggest faffage to take the bike on and off. But for long term winter storage it is perfect, or the three times i have used it this year...
I purchased the ABBA superbike package three to take the wheels off the floor, and to move it around the garage.
World's biggest faffage to take the bike on and off. But for long term winter storage it is perfect, or the three times i have used it this year...
CAPP0 said:
These things would be great if they were about a foot wide, so that you could park a bike on them when not using it for working on,]
I've only got a small garage and do just that, its set out just right so I can park on it and still get the other bikes in, if you have a small garage like mine then you are limited to 3 bikes though. 
CAPP0 said:
These things would be great if they were about a foot wide, so that you could park a bike on them when not using it for working on, but it wouldn't get in the way.
I do just that, park one bike on the platform. OK it's a few inches off the ground and it has a slightly larger footprint than a bike but no problem.
Plus with 3 Italian bikes, one normally needs to be on it anyway...

mak said:
CAPP0 said:
These things would be great if they were about a foot wide, so that you could park a bike on them when not using it for working on,]
I've only got a small garage and do just that, its set out just right so I can park on it and still get the other bikes in, if you have a small garage like mine then you are limited to 3 bikes though. 
pozi said:
If you wanted to keep your bike warm would it not have been cheaper and easier to just mount the heater lower??
I don’t want to put direct heat on the bike, but want to keep the whole shed dry, so placement of the heater isn’t really a concern, plus it is out of the way. The shed is insulated and as the thermostat is remote, as it’s placement is more important than the actual heater, it can be placed low down for the really cold nights. Gassing Station | Biker Banter | Top of Page | What's New | My Stuff




