Old British twins
Author
Discussion

Vipers

Original Poster:

33,525 posts

259 months

Saturday 7th October 2017
quotequote all
On the old vertical twins, did the pistons come up together, or was one down when the other was up.

Just wondering having seen a post on FB, it said -

The Matchless G9 500 twin had pistons raising together and was the first motorcycle engine to exceed 5000 rpm

Edited by Vipers on Saturday 7th October 20:45

tvrolet

4,771 posts

313 months

Saturday 7th October 2017
quotequote all
Up and down together, so sounds like a nice even during order. Japanese twins like the Honda 250 etc in the early 70s was the first thing I came across with pistons going ip and down alternately and it gave them that plup plup plup sound...or so it sounded to me anyway. No doubt there were loads of earlier examples too, but not the classic British stuff.

Back in the mists of time when I was a yoof messing with a 750 commando it was always the bottom end that was the weak point as it flexed at high (it’s all relative) revs.

crofty1984

17,064 posts

235 months

Sunday 8th October 2017
quotequote all
360 degree crank, so yes, up and down together.

Vipers

Original Poster:

33,525 posts

259 months

Sunday 8th October 2017
quotequote all
Tks guys.

gareth_r

6,791 posts

268 months

Sunday 8th October 2017
quotequote all
tvrolet said:
...Back in the mists of time when I was a yoof messing with a 750 commando it was always the bottom end that was the weak point as it flexed at high (it’s all relative) revs.
Bolted-together 3-piece crank (and no centre main bearing), not surprising that it flexed. smile

All the British twins ended up way beyond their original design parameters.

Funnily enough, the Matchless/AJS twins were the only British parallel twins with a centre main. They weren't the first bike engines to exceed 5000 rpm, though. That certainly happened pre-war (IIRC the 1938 Speed Twin revved past 6000), my guess would be in the 1920s.

Wacky Racer

41,412 posts

278 months

Monday 9th October 2017
quotequote all
The smoothest unit construction Triumph twins were the 350 and 500 examples.

When Meriden expanded them to 650cc vibration started to become an issue, more so when they went to 750 later on.

dirkgently

2,160 posts

262 months

Monday 9th October 2017
quotequote all
Vibration wise 180 or 360 makes no difference you still have the vibration characteristics of a single, to deal with the vibration you need a 72deg crank. I think Norman Hide did a kit for the Bonneville but it was eye wateringly expensive at about £300.

xeny

5,539 posts

109 months

Tuesday 10th October 2017
quotequote all
Eh? 180 degree crank the pistons move in opposition, so you get a rocking couple along the crank, quite different from a 360 degree crank or a single where all you have balancing the piston's weight is the crankshaft balance weights.

dirkgently

2,160 posts

262 months

Wednesday 11th October 2017
quotequote all
xeny said:
Eh? 180 degree crank the pistons move in opposition, so you get a rocking couple along the crank, quite different from a 360 degree crank or a single where all you have balancing the piston's weight is the crankshaft balance weights.
The vibration characteristics are still the same up and down. triples and fives are offset hence much smother. Its a bit more complicated than that but that`s the gist.