A job never goes simple.
Discussion
Replaced the wheel and head bearings and fork oil in my bike as needed doing.
Buttoned or back up, torqued to specs. Now it's got a real bad slow weve and gets wobbly banked over around corners at speed. At slow speed feels like it wants to lean left, then right and so on.
Irritating. I torqued the head bearing to spec, 25nm but wonder if it's too tight.
Guess I'll have it all apart again and put it all back together for a 2nd time checking all as I go. Fun!
Buttoned or back up, torqued to specs. Now it's got a real bad slow weve and gets wobbly banked over around corners at speed. At slow speed feels like it wants to lean left, then right and so on.
Irritating. I torqued the head bearing to spec, 25nm but wonder if it's too tight.
Guess I'll have it all apart again and put it all back together for a 2nd time checking all as I go. Fun!
Xtriple129 said:
Head bearings too tight mate. Are you sure it's torque it up and leave it? Quite often you torque up to seat everything, then back off and do it to a lower spec..
Will check. I have the Honda service manual. It says (from memory) tighten to 25nm then move yoke side to side 5 times then check torque is still 25.
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


