Is the sound of a duff starter solenoid?
Discussion
Hi
As covered in a previous thread, after much faffing I finally managed to get my 01 ZX6R starting and running well by changing the plugs. All was well for a while, but I suspect I didn't tighten them up enough, as the bike started running rough AF and I think it was on 3 cylinders. Rode home and tightened the plugs half a turn but now it won't start. I don't think it's related to the plugs, I think all the non starting has taken its toll on the poor starter motor or solenoid/relay. Could someone please advise if that my diagnosis is right, from the following video? Dramatic video footage due to pointing the camera at the sound. I.e. big click from the relay followed by clicking from starter. Worth getting out the voltmeter or shall I just get a new relay? Or could it be the starter motor itself? As ever, all advice welcomed. Thanks
https://youtu.be/wSSPh9ZZ7oE
As covered in a previous thread, after much faffing I finally managed to get my 01 ZX6R starting and running well by changing the plugs. All was well for a while, but I suspect I didn't tighten them up enough, as the bike started running rough AF and I think it was on 3 cylinders. Rode home and tightened the plugs half a turn but now it won't start. I don't think it's related to the plugs, I think all the non starting has taken its toll on the poor starter motor or solenoid/relay. Could someone please advise if that my diagnosis is right, from the following video? Dramatic video footage due to pointing the camera at the sound. I.e. big click from the relay followed by clicking from starter. Worth getting out the voltmeter or shall I just get a new relay? Or could it be the starter motor itself? As ever, all advice welcomed. Thanks
https://youtu.be/wSSPh9ZZ7oE
Just sorted something similar on my brother’s bike.
Check the voltage on the battery first.
Pop the solenoid off, put power to the lead that goes to the ignition relay and then check for resistance across the poles and continuity.
The one on my brother’s bike clicked etc. But there was no continuity.
New relay and solenoid the next day and bike was sorted.
Check the voltage on the battery first.
Pop the solenoid off, put power to the lead that goes to the ignition relay and then check for resistance across the poles and continuity.
The one on my brother’s bike clicked etc. But there was no continuity.
New relay and solenoid the next day and bike was sorted.
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


