locking end can bolts?

[gixxer1000]

Folks, some scum-bag recently made off with my lovely Yoshimura Tri-oval end can and I am now keen to buy some locking bolts if such a thing exists. Had a quick scoot around the interweb and couldn't find anything. Even flee-bay didn't list anything. Do they exist? Do they work? Where can I but them?

All help appreciated.

Gixxer


>> Edited by gixxer1000 on Tuesday 11th April 22:47

[BobM]

What size bolts are they? Do they have nuts on them?

Screwfix sell security nuts where the hex bit shears off. There are also the sort that have a Torx socket head with a pin in it that require a special security bit, you can get those here.

Other thoughts are to use a permanent grade of loctite, although not sure what would happen with the heat. Or sometimes it's possible to file a bolt head to chamfer off the slot or hex such that you can tighten it but not slacken it.

[bimsb6]

i think m and p do such a thing ,its a bit like a locking car wheel nut in that it needs a corresponding socket to undo or do up alsop try demon tweeks

[bimsb6]

www.mandp.co.uk/list.aspx?tier1=Exhausts&tier2=Exhaust+other&tier3=Motrax

[gixxer1000]

Thanks chaps. I'll look into these suggestions.

Gixxer.