Funny noise
Author
Discussion

Matthew-TMM

Original Poster:

4,028 posts

268 months

Thursday 25th September 2008
quotequote all
Hi folks, if I raise the revs of my bike to a fast idle (1500-2000rpm) when it's warm or hot, it makes an intermittent single knock, accompanied by a drop in the revs of perhaps 3-400rpm for perhaps 1/2 a second. As it doesn't do it below or above this rev range and it's got no worse in the few hundred miles since I noticed it, I think I can safely assume it's not a mechanical snag. I chacked the ignition timing today, just in case it occasionally made an erroneous spark hugely advanced, but the timing seems to be fine. It's one of those noises that could be nothing or could be cause for concern, so I want to get to the bottom of it, hopefully just to put my mind at rest. Could it just be spitting back through the carbs?

Edited by Matthew-TMM on Thursday 25th September 17:01

ssray

1,383 posts

256 months

Thursday 25th September 2008
quotequote all
what is it for a start?

Matthew-TMM

Original Poster:

4,028 posts

268 months

Thursday 25th September 2008
quotequote all
It's a GS500. It's not a regular noise, on investigation, it might happen twice in 10 seconds, or it might be a minute or more between. As it only happens at those revs, I doubt it's mechanical wear or any sort of snagging anywhere (say from a lump of debris in the sump getting into things).

I don't know what spitting back through carbs sounds like on an engine with an airbox, so perhaps someone could give me a description?

Edited by Matthew-TMM on Thursday 25th September 21:00

freddytin

1,184 posts

258 months

Thursday 25th September 2008
quotequote all
Have you tried placing your hand on the cam chain tensioner housing whilst the noise is present ?

If not , give it a try . HTH

Matthew-TMM

Original Poster:

4,028 posts

268 months

Thursday 25th September 2008
quotequote all
I'll give it a go, although it may be a bit too warm to hold my hand on by the time the engine's warmed up enough for it to happen. What should I be expecting by trying that?

freddytin

1,184 posts

258 months

Thursday 25th September 2008
quotequote all
If you can feel the impact of the knock, then it is likely to be tensioner that's at fault.

Dependant on the model you should be able to repair/replace quite easily.

Matthew-TMM

Original Poster:

4,028 posts

268 months

Thursday 25th September 2008
quotequote all
Thanks, I'll try that tomorrow.

Busamav

2,954 posts

239 months

Friday 26th September 2008
quotequote all
I would pull the pluigs out first .

Also whilst your getting your hands dirty , check the air filter .

If the revs are dropping , it suggests to me that it is misfiring slightly

Edited by Busamav on Friday 26th September 08:35

Hyperion

16,952 posts

231 months

Friday 26th September 2008
quotequote all
Matthew-TMM said:
I chacked the ignition timing today, just in case it occasionally made an erroneous spark hugely advanced
Can you elaborate on this 'erroneous spart' you mention? I'm not sure if you're saying it IS making odd sparks, or isn't?
If it's firing when it shouldn't, the knocking will be caused by detonation during the wrong part of the cycle. This can quickly destroy engines if left unchecked.

Edited by Hyperion on Friday 26th September 09:17

97rsr

258 posts

243 months

Friday 26th September 2008
quotequote all
Is it pinking? My DRZ used to unless I used optimax but only when really hot i.e when filtering. BMW 1200 does as well but less, only when really hot again.

black-k1

12,817 posts

260 months

Friday 26th September 2008
quotequote all
I would expect that it is ‘pinking’ that is the problem, the question is why? It could be caused by this ‘erroneous spark’ you mention but that should not be happening so would need further investigation. It also could be that the mixture on your bike is very lean (to make it as economical as possible) and that at that throttle opening/engine speed it’s just a little too lean and causing a bit of pre-detonation. (Will be worse when it’s hot) This is not a big problem providing the plugs show that the mixture is OK on general use, under load and with more throttle. It would be worth checking for inlet leaks just in case and if you have a ‘freer flowing end can’ (read louder) or high flow air filter fitted then these could also be part of the problem.

Matthew-TMM

Original Poster:

4,028 posts

268 months

Friday 26th September 2008
quotequote all
The bit about ignition timing was just postulating. I checked it and it seems to be in order, so it's not that. FYI this is happening under no load. It is backfiring through the carbs though. Both spark plugs weren't done up very tight at all and both insulator noses were white/brown which seems OK, except that both have some speckled deposits, which is not OK. Air filter and exhaust are both standard. Time to look for air leaks I think.