New hugger - too close to tyre?
Discussion
Fitted a Pyramid hugger to my CBF yesterday. It's not sitting square over the wheel. I'm not so bothered about symmetry, but on one side it's looking very close to tyre (I reckon about 5mm). However much I try to adjust I can't seem to get a bigger gap.
Those with huggers - how does this look to you? This thing wasn't cheap, so if it's not right it might have to go back.



Those with huggers - how does this look to you? This thing wasn't cheap, so if it's not right it might have to go back.
Edited by surfsofa on Monday 29th September 12:03
Thats a little too close. The one that was fitted on my bike when I bought it sat too close as well, and it chipped the edge quite badly with stones that were dragged up with the tire.
I replaced it, but that one too sat too close. It didnt have the swinging arm part of it, so to raise it, all I did was put a couple of washers under the outermost bolts, with none in the middle. As I tightened the middle one, it lifted the rear of the hugger to the perfect position.
Then, for aesthetics as much as edge protection, I got some screen edging and put that all round the hugger. Looks ok I think.
I replaced it, but that one too sat too close. It didnt have the swinging arm part of it, so to raise it, all I did was put a couple of washers under the outermost bolts, with none in the middle. As I tightened the middle one, it lifted the rear of the hugger to the perfect position.
Then, for aesthetics as much as edge protection, I got some screen edging and put that all round the hugger. Looks ok I think.
Thanks all. I'm wondering if a couple of washers might raise the offside enough. There are only 3 mountpoints on the hugger - 2 on the nearside and one on the offside which re-uses one of the P-clips that guide the brake lines along the swingarm. A couple of washers under that might do the trick. I reckon a centimetre would be enough clearance.
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


