Do bikes suffer more from lumpy idle/fuelling vs cars?
Do bikes suffer more from lumpy idle/fuelling vs cars?
Author
Discussion

surfsofa

Original Poster:

406 posts

314 months

Wednesday 8th October 2008
quotequote all
My bike seems pretty unhappy when cold. It'll often stall when tweaking the choke in or out and always seems to have a relatively lumpy idle, certainly compared to my car. Idle revs are around 1000rpm.

Is this common or might I have some dirt in the system somewhere?

steveo29

1,885 posts

220 months

Wednesday 8th October 2008
quotequote all
unsure, if it does that when cold, give 2-3 mins for it to warm up, me having a 2stroke i need to do that anyway tongue out

Steve_T

6,356 posts

303 months

Wednesday 8th October 2008
quotequote all
Depends on the bike, but mostly likely is that the carbs/throttle bodies need balancing against one another to improve the idle.

RizzoTheRat

29,169 posts

223 months

Wednesday 8th October 2008
quotequote all
Presume it's carbs? As Steve said blanacing could well help, but if you're running an atermarket pipe or airfilters has it been rejetted to match them? If not it could be running lean all across the rev range which could cause the low rev lumpiness. Depending on the mileage you could have some worn components. I changed my emulsion tubes a couple of years back and got a smoother idle, more low down torque, and a big decrease in fuel consumption.

StevRS

443 posts

240 months

Wednesday 8th October 2008
quotequote all
Mine's a twin & has had carb rebuild & balance & full service & it idles lumpier than my car...

Sossige

3,176 posts

294 months

Wednesday 8th October 2008
quotequote all
Hi Simon -

Check that the plugs aren't fouled up for a start. The idle speed is a little lower than I have my Hornet set to - what's the owner's/Haynes manual say?

If you fancy balancing the carbs, I have a synchronometer you can use from the days that I needed it for some Weber carbs.

S

Hooli

32,278 posts

231 months

Wednesday 8th October 2008
quotequote all
surfsofa said:
Idle revs are around 1000rpm.
sounds low to me, most bikes i've ridden seem to idle nearer 1,500rpm. whats the manual say?

Steve_T

6,356 posts

303 months

Wednesday 8th October 2008
quotequote all
Agree with all the points posted. My SV and Falco both should idle around 1350 rpm and I'd note that as you improve the idle smoothness by balancing the air flow and therefore the power generated on each cylinder firing, you will pick idle speed as a natural consequence. This may be your problem. In terms of lean running, partly it may be due to an aftermarket can, but also it tends to be the case that manufacturers often fit an undersized idle jet in carbs to pass the emissions tests they're subject to. Injected bikes tend to be mapped lean for the same reasons. Hesitancy as you roll on the throttle is a common problem resulting from such lean fueling. If your bike hasn't been serviced for a bit then new plugs and a carb/tb sync will likely be part of this and may be all that's required to sort things out. Start with getting the bike running to the manufacturers specs before you look at anything else more complicated. If you're comfortable looking at things yourself, I'd recommend a Morgan Carbtune as the tool to help balance things up.

Cheers,

Steve.

surfsofa

Original Poster:

406 posts

314 months

Thursday 9th October 2008
quotequote all
Thanks all. Manual says idle should be 1350rpm, so I'll tweak that upwards and see what that does.

As for removing spark plugs and balancing carbs, I think that'll be a job for someone who knows what they're doing (ie. not me). smile

StevRS

443 posts

240 months

Thursday 9th October 2008
quotequote all
Get yourself a haynes manual and have a go - they're simple things, really!

surfsofa

Original Poster:

406 posts

314 months

Thursday 9th October 2008
quotequote all
StevRS said:
Get yourself a haynes manual and have a go - they're simple things, really!
I do want to learn some of this stuff. First I have to get tools and the manual, as you say. I'm hoping to get a new bike next year at which point I may well keep my current one and have a go at stripping it down and learning the ropes. Will be more fun in warmer weather too.

Steve_T

6,356 posts

303 months

Thursday 9th October 2008
quotequote all
Where are you based Simon? If someone is local to you they may be able to help you out.