MOT fail for lights 'kicking' the wrong way
MOT fail for lights 'kicking' the wrong way
Author
Discussion

Tyrant

Original Poster:

663 posts

261 months

Friday 10th October 2008
quotequote all
A friends Cagiva Mito has failed it's MOT for the above reason. I thought that it may be a case of turning around the shield within the headlight unit and offered to take it off and have a look for him. It turns out that the shield is curved and was wondering if I could still get away with rotating it as in the pics below (I can't try it on the bike and see what effect it has for a few days). Any other possible solutions are very welcome!


catso

16,584 posts

298 months

Friday 10th October 2008
quotequote all
Looks like the plate in my 916 headlight. When I bought it it dipped the wrong way, I took out the plate and made a mirror image of it in stainless steel which works fine but as it's curved I don't think turning it round would work - may be able to buy a new correct side plate? (but might only sell whole headlight) otherwise stick a beam deflector (black tape) to the light for the MOT.

Edited to add; it probably is the same light unit as a 916 as the fairing design is virtually the same, if so look for a 916/748 etc headlight unit on ebay or a breakers, lenses often break but the part you need would likely still be intact.


Edited by catso on Friday 10th October 22:24

phillvr6

3,785 posts

291 months

Saturday 11th October 2008
quotequote all
This is a problem with some aprilias, you can get around it by sticking tape on the light in the same way you would if you took a UK bike to europe.

Hooli

32,278 posts

231 months

Saturday 11th October 2008
quotequote all
phillvr6 said:
you can get around it by sticking tape on the light
you'll pass with an advisory for that, at least my bike did because i cant be bothered to remove the tape from when ive been over the water.

Tyrant

Original Poster:

663 posts

261 months

Saturday 11th October 2008
quotequote all
Is it likely to fail if I 'removed' the kick by straightening out the top of that plate?

I guess it might be worth seeing if someone can make up a mirror image like on your Ducati catso. Otherwise I'll try some tape but I figured it would be quite difficult on a projector light.

Thanks!

catso

16,584 posts

298 months

Saturday 11th October 2008
quotequote all
Tyrant said:
Is it likely to fail if I 'removed' the kick by straightening out the top of that plate?
If you take out the kick, it will shine flat ie not kickup to the side anymore, this should pass MOT I would think (and be OK for 'LH drive' version too). If you can fill in the 'slope' then you only need to cut an identical one the other side to get the right shape but IIRC it's made from some cheapo material so not easy to mod.

I made mine from a piece of thin stainless plate but couldn't press it into the right shape so had to cut & weld. If it's not a rush try finding a crashed Ducati 748/916/996/998 (should be more of these than Mitos) even if the light's broke chances are the plate's intact.