Ashcroft Transmissions
Ashcroft Transmissions
Author
Discussion

Pozzy

Original Poster:

132 posts

194 months

Wednesday 6th June 2012
quotequote all
Has anybody used these guys for a reconditioned LT77 before, as they offer a same-day turnaround including new clutch for around £1100 which sounds (to me) quite reasonable?

The reason I ask is that it looks like something has gone to pieces with the selector mechanism on my gearbox - to say the gearstick is baggy now is an understatement! To add to this, second gear has had a distinct whine to it for a while now, so I'm wondering whether to bite the bullet and just get the whole shooting match replaced instead of spending a few hundred quid getting the selector problem sorted only to find six months down the road that second gear has gone as well.

If Ashcroft aren't recommended, is there anyone else to consider, bearing in mind the car is my daily driver so I can't do without it for very long?!

300bhp/ton

41,030 posts

220 months

Wednesday 6th June 2012
quotequote all
They have a great rep in the LR world.

wuckfitracing

991 posts

173 months

Wednesday 6th June 2012
quotequote all
Know them well, again from the landrover world I used to race a Bowler up until a few months ago. Highy reputable and do an excellent job.

blitzracing

6,422 posts

250 months

Wednesday 6th June 2012
quotequote all
If the TVR uses the same gear (remote)shift mechanism as the Ginetta, the whole gear selector mechanism bolts on the back of the gearbox with 4 rubber bushed bolts. The problem is the rubber fails over time and then the whole gear shift starts moving about, it feels like a major selector failure. It just needs about £3 worth rubber bushes to sort it out.I cut a panel out of the transmission tunnel to get access to the upper ones, but I dont know how good the access is on the TVR.



Edited by blitzracing on Wednesday 6th June 21:25

carsy

3,019 posts

195 months

Wednesday 6th June 2012
quotequote all
The remote linkage on the LT77 Griffs is different to the One shown SD1. Its TVR specific. There arent the same rubber bushes. I would therefore assume the Chim LT77 uses the same as the Griff.

The gearlever itself sits in a bush type affair which wears. When worn gives a sloppy gearchange and poor gear selection as you are experiencing. Worth trying changing this first for a few pounds.

http://mobile.pistonheads.com/co/uk/gassing/topic....

Pozzy

Original Poster:

132 posts

194 months

Friday 8th June 2012
quotequote all
Thanks very much for the replies gents, I will try and have a go at the bush replacement before going whole-hog with the refurb. It seems Ashcroft aren't too up for doing the job on a TVR anyway, so it gives me a good excuse to have a fiddle myself. Better have a spare car ready in case I muck it up though!

K4TRV

1,819 posts

282 months

Friday 8th June 2012
quotequote all
Pozzy said:
Thanks very much for the replies gents, I will try and have a go at the bush replacement before going whole-hog with the refurb. It seems Ashcroft aren't too up for doing the job on a TVR anyway, so it gives me a good excuse to have a fiddle myself. Better have a spare car ready in case I muck it up though!
Hi,

I received a recommendation to try these guys: http://www.klassiktrans.co.uk/

They rebuilt a colleagues LT 77 in the S Series and he uses it for Sprints/Hillclimbs. I think it was an earlier version of our H (the last & latest & strongest) series.

They may offer to remove and rebuild & replace??

As you've discovered Ashcroft are mainstream Land Rover - their rebuilt box does sound a solid product?

HTH's? Grateful for any feedback?

Trev