Under bonnet heat reflector sheet

[CHIMV8]

Where can you buy the heat sheet that is stuck on the underside of the bonnet

[tvrman]

http://www.demon-tweeks.co.uk/motorsport/heat-shie...

[jfjfjf2]

http://www.agriemach.com/

Loads of good stuff.

[CHIMV8]

Jesus this stuff is espensive>>

[Meatball]

Wasent there a guy on here making them up ? was a little while back mind you.

[CHIMV8]

Meatball said:

Wasent there a guy on here making them up ? was a little while back mind you.

Come on man show yourself please

[kevin63]

This stuff looks like what's normally on TVRs, the problem would be the glue used to hold it on.
http://www.ebay.co.uk/itm/Heat-Shield-Aluminised-M...

[Engineer1949]

That looks to be the stuff bit short though i have emailled them to see if they would supply longer pieces so no joining to do



John

[carsy]

Clever Trevor used to sell this stuff, same as the ebay one. Got some last year and was only about £20 for a square meter. I presume they still sell it.

[kevin63]

Engineer1949 said:

That looks to be the stuff bit short though i have emailled them to see if they would supply longer pieces so no joining to do



John

They have larger sections and also on eBay.

[DoctorBonzo]

My heat reflector material is falling off. Any suggestions on what to stick it back with? Spray-on glue? Or is there some special heat-resistant compound that should be used?

[brett84]

sikaflex would do it, just need to find a way to hold it in place for a couple hours while it sets

[SILICONEKID340HP]

i would use heat resistant silicone ,sikaflex as come off om my inner wings .

Have you thougt about going to the scrap yard ,loads of cars with far better matarial than that silver stuff.

It`s worth a look .

Edited by SILICONEKID340HP on Monday 13th August 21:23

[DVR V8]

Just completed this job on mine.The best material i found was from racetech direct[same as original].Fraction of demon tweeks prices.Also had to buy high temp contact adhesive from woolies[£17.00per litre].It takes nearly a litre to cover both surfaces.Hope this helps.