Wont rev more than 2500 rpm

[The Lodge]

Got Chim running after fitting a stealth cam and 72mm plenum

Mill lamp is on but cant plug it in to a code reader untill tomorrow

any ideas, it seems to be the same throttle position in each gear

It stops reving very quickly i nearly head but the screen.

Thanks

Paul.

[debaron]

Have you reset the ECU and replugged up Airflow meter up properly?

The MIL lamp usually happens when a sensor goes out of range and then even sometimes not - a lot of them aren't even wired up! Double check every connection and see how it is then.

HTH

Ryan

[The Lodge]

Plugged it into autologic and it came up with

throttle position sensor, and air flow / tps correlation fault.

you can monitor what the engine is doing and at idle it was reading 0.59 volts when gently building up the revs this figure staid the same until about 2000 rpm

I cleared the faults but still no good, throttle pot fault came back.

When i finally disconnected the ecu and plugged it in again it was fine....should have done that yesterday.

Thanks for your help Ryan.