std injectors for a 4.3 - rr p38?
Discussion
Std Lucas RR3.9 injectors (185 cc/min @2.5 bar) - don't have the parts numbers handy.
Though if you need to buy them anyway, you might consider the Vauxhall/Opel X18XE/X20XEV injectors (GM 90501588) instead, they are vastly superior to the pintle type Lucas ones and as they're rated at 250 cc/min @3.0 bar you may find they'll be close enough for the CUX14 to adapt on the factory map settings, especially on the larger engined cars that tend to run a bit lean towards the top end on the std mapping
Of course, you can always ask Mark Adams for a chip to go with the Vectra inj's to be on the safe side, will likely give a fairly significant improvement in driveability together
Though if you need to buy them anyway, you might consider the Vauxhall/Opel X18XE/X20XEV injectors (GM 90501588) instead, they are vastly superior to the pintle type Lucas ones and as they're rated at 250 cc/min @3.0 bar you may find they'll be close enough for the CUX14 to adapt on the factory map settings, especially on the larger engined cars that tend to run a bit lean towards the top end on the std mapping
Of course, you can always ask Mark Adams for a chip to go with the Vectra inj's to be on the safe side, will likely give a fairly significant improvement in driveability together
Edited by 900T-R on Tuesday 24th July 20:19
Alexdaredevilz said:
Pm haircutmike I 'think' he's selling a set of vectors injectors
I would imagine he as a set of the stockers/Hotwire too 
I have sold a used set and a set of serviced/Ultrasonically cleaned Hotwire inj's in the last 3 months too 
Edited by Simon says on Tuesday 24th July 20:52
Gassing Station | Chimaera | Top of Page | What's New | My Stuff