ARP torque settings?

[dbv8]

So my crank is finally back in the block

I am using ARP main studs.
Is 80 ft/lb about right for the nuts?
What torque setting do i use for the crossbolts?

[carsy]

Not too sure on the ARP Mains, but Mr. RPI says this about the crossbolts.

http://www.youtube.com/watch?v=wYyBK960GRU

[dbv8]

carsy said:

Not too sure on the ARP Mains, but Mr. RPI says this about the crossbolts.

http://www.youtube.com/watch?v=wYyBK960GRU

Whats all that double clicking about?
Some interesting comments beneath that clip also.

[Alexdaredevilz]

Not much help but I do know that studs require a different tightness than bolts, I'd email arp or ring then they should still be open

[Simon says]

dbv8 said:

carsy said:

Not too sure on the ARP Mains, but Mr. RPI says this about the crossbolts.

http://www.youtube.com/watch?v=wYyBK960GRU

Whats all that double clicking about?
Some interesting comments beneath that clip also.

Its like an old mechanics double check Derek it does not alter torque applied or anything just habit I guess you will always get bhing on Youtube i didnt rtead all the comments or the vid so .....

Edited by Simon says on Monday 13th August 22:30

[haircutmike]

http://www.mez.co.uk/TuningTheRoverV8-pt11.html

[dbv8]

haircutmike said:

http://www.mez.co.uk/TuningTheRoverV8-pt11.html

A useful page but nothing about crossbolts or ARP.

Lots of thunder n lightning down here.... hows the weather in Ambleside?

[haircutmike]

10 min shower earlier.

Leaving for the west coast in the morning, weather looks distinctly average!

Maybe try Tim at ACT in the morning as he sells them.

[debaron]

Alexdaredevilz said:

Not much help but I do know that studs require a different tightness than bolts, I'd email arp or ring then they should still be open

the studs should only be done up hand tight (I did 8 Nm on my head studs) - if you know your kit number, there is a section on the ARP site where you can plug it in and it will tell you all the settings.