Chrimaera suspension
Chrimaera suspension
Author
Discussion

paramount1443

Original Poster:

68 posts

172 months

Monday 8th July 2013
quotequote all
Recently bought a 1998 4.0Lt Chrimaera with 36000 miles but the ride on normal roads is terrible, o`k on smooth motorways.
Could it be the rear shocks need replacing although low milage ?

Thought of replacing with new adjustable GAZ shocks - Any advise would be welcome

Paramount 1443

sapper

1,134 posts

235 months

Monday 8th July 2013
quotequote all
Check your drop links and bushes, with 36000 your shocks should be ok. If not it might be worth getting them refurbed.

jamienshelly

1,826 posts

168 months

Monday 8th July 2013
quotequote all
Hi, How do you mean terrible?. does it wallow round corners and you can feel the rear end rolling, or is over pot holes etc it rattles and feels hard with bump steer?.

paramount1443

Original Poster:

68 posts

172 months

Monday 8th July 2013
quotequote all
Hi,
Does not wallow but has a knocking on the n/s rear. Its driving over unevan / potholed roads that the problem feels like there is no damping

OleVix

1,438 posts

178 months

Monday 8th July 2013
quotequote all
low milage or not, 15 years on the same shocks is not good, change them for fresh bilsteins or adjustable nitrons/AST. People seem to be having issues with the Gaz's... squeeking, bouncy ride etc.

jamienshelly

1,826 posts

168 months

Monday 8th July 2013
quotequote all
paramount1443 said:
Hi,
Does not wallow but has a knocking on the n/s rear. Its driving over unevan / potholed roads that the problem feels like there is no damping
I would check your anti roll bar link arms or bushes, if it was your shocks it would more than likely be very bouncy and wallowy.

QBee

22,493 posts

174 months

Monday 8th July 2013
quotequote all
I'd take it to a man who knows what he is looking at, ie a TVR specialist, and see what he says. And if he says all is well with the shocks and other suspension joints, get a four wheel alignment done - changed mine from dangerous to fun.

paramount1443

Original Poster:

68 posts

172 months

Tuesday 9th July 2013
quotequote all
Taken your advise & taken it to a Garage in Cardiff who knows about TVRs


TJC46

2,199 posts

236 months

Tuesday 9th July 2013
quotequote all
Check your tyre pressures!

A good start point is 22psi front and 24 psi rear.

To much tyre pressure makes these cars an absolute pig to drive!

QBee

22,493 posts

174 months

Tuesday 9th July 2013
quotequote all
TJC46 said:
Check your tyre pressures!

A good start point is 22psi front and 24 psi rear.

To much tyre pressure makes these cars an absolute pig to drive!
That's a good point. If it has been near any Kwik Fit (other high street tyre places are available) recently, the tyre pressures will be at bouncy castle settings.

paramount1443

Original Poster:

68 posts

172 months

Thursday 11th July 2013
quotequote all
So far the garage has found one of the exhaust pipes has no support bracket, seized suspension bushes
& front wheel tracking out so all suggestions were correct, Thanks guys.

Paramount1443

QBee

22,493 posts

174 months

Thursday 11th July 2013
quotequote all
paramount1443 said:
So far the garage has found one of the exhaust pipes has no support bracket, seized suspension bushes
& front wheel tracking out so all suggestions were correct, Thanks guys.

Paramount1443
Good - still check the tyre pressures are 22/24 as stated above - most non-TVR garages are surprised when you tell them these settings, but the previous poster is correct - too much air in the tyres makes it bounce like hell!

paramount1443

Original Poster:

68 posts

172 months

Thursday 11th July 2013
quotequote all
The garage in Cardiff are TVR specialist so should be o`k but still think I should fit adjustable dampers

QBee

22,493 posts

174 months

Thursday 11th July 2013
quotequote all
What are your plans for the car?
If you are staying on the Queen's highway, and the original Bilsteins are still on it and are not shagged, then I would stay with them. They are excellent, expensive dampers that were specced by TVR for the car, and TVR did actually know what they were doing.
If you are planning on track-daying, then adjustables make sense so that you can stiffen the dampers when on track. It's a knob on each damper, just requires lying on your back by the car and grunting as you try to turn the knob. Worth finding out which dampers are easier to adjust. I will be, before I change my shagged front dampers!!

paramount1443

Original Poster:

68 posts

172 months

Thursday 11th July 2013
quotequote all
No only road use. won`t adjustable give a softer ride ?

Trevor450

1,936 posts

178 months

Thursday 11th July 2013
quotequote all
+1 for the original Eibach springs and Bilstein dampers. I had all mine renewed (along with the relevant bushes) when my 12 year old car blew the oil out of one of its dampers and the difference to the handling was night and day - they are superb on road and not that bad on track. I was overtaking plenty of stuff and managing not to get in the way around the corners at Blyton recently.

http://www.pistonheads.com/gassing/topic.asp?h=0&a...

In terms of ride, I think they standard stuff is very good.

QBee

22,493 posts

174 months

Thursday 11th July 2013
quotequote all
paramount1443 said:
No only road use. won`t adjustable give a softer ride ?
You'd only really buy them to go stiffer. The standard are quite soft enough. If you want a soft ride, try my Audi A8 with computer controlled air suspension.

The key to a good TVR ride is the tyre pressures being correct (do check), dampers and springs being in good working order, and having the car four wheel aligned - the latter changed my car from "Oh my God, what have I bought, this car is totally unpredictable", to "WOW!!!!! this car really handles"

paramount1443

Original Poster:

68 posts

172 months

Thursday 11th July 2013
quotequote all
I`ll take you advise thanks.

rigga

8,806 posts

231 months

Thursday 11th July 2013
quotequote all
General opinion is that the standard billies are undersprung, so should you decide to go after market most if not all spec stiffer spring rates.