Splitter size.

[Pink_Floyd]

Anyone tell me the size of the splitter at the front of the car and the angle it is bent at.
Thanks

[SILICONEKID343HP]

This may help ..

[QBee]

It is 90 cm long, and about 6-8 cm wide. You can get them from the regular TVR parts suppliers for about £20-40.
TVR power sell the steel ones as in the above pic for £30 plus.

Clever Trevor sells this

View detailsSPOILER, LIP PART No, U0890
Part No U0890
Front lip spoiler manufactured in GRP, fits Griffith and Chimaera, often gets damaged or ripped off over rough ground

£20.34 (including VAT)

IMHO, the stainless ones stand a better chance of surviving an incident with a speed hump

Edited by QBee on Wednesday 24th July 19:21

[miniman]

Mine lasted about 10 miles. On the plus side, it was ripped off whilst in the process of decapitating a squirrel.

[TJC46]

miniman said:

Mine lasted about 10 miles. On the plus side, it was ripped off whilst in the process of decapitating a squirrel.

Oh dear the poor little splitter.Hope it wasnt covered in too much blood.

[seeby]

Splitter size ? I didn't think it mattered, as long as it works. My Chim didn't have one when I got the car. I had the old bonnet flapping problem ,so I fitted a Lino Edge door threshold. It doesn't drop down very far but it certainly works,and it didn't cost anywhere near £20 . You can get one from a carpet shop.

[fatboychim]

Size isn't critical so long as it disrupts the airflow around the bottom of the car. This gives some ideas

http://www.pistonheads.com/gassing/topic.asp?h=0&a...

I bought enough material to make 6 spoilers, cost £7.50