Looking for some parts please

[TV8]

I am going to change some of the bits on my car before it is remaped next month. A bit of a long-shot but if anyone has any of the following that they want to sell, please do let me know by PM Thanks

72mm plenum
up-rated injectors
original 20AM AFM
larger trumpets - ally or the ACT ones
Ported manifolds
Good condition exhaust manifolds (not Y piece), ideally with the pre-cats removed.

If I have forgotten anything on the top of the engine that is a typical mod, please let me know!

Thanks for reading.

Graham

[Chuffmeister]

You can do the trumpets yourself. These need a little work to get them in and it is tight. I did them myself; took me about two afternoons.

More ideas on induction mods here: http://www.mez.co.uk/ms12.html

http://stores.spencerashley.com/-strse-737/ROVER-V...

There is a set of manifolds for sale here:
http://www.ebay.co.uk/itm/TVR-Chimaera-Griffith-Ex...

Otherwise, get your self over to V8 Developments http://www.v8developments.co.uk/technical/inductio... or speak to John Eales.

[TV8]

Thanks Christian. I have dropped Rob a line and thought I would ask the question on here just in case!

[SILICONEKID346HP]

Can`t see a larger bored 72mm plenum ,Trumpet base with 45mm trumpets and larger injectors would make any difference on a 4l .

Why would you have a ported inlet manifold without ported heads ?

[TV8]

Its not a 400. I must change my profile - 5.3 V8Dev, small amount of work on the standard 500 heads and a MC1 cam with a couple of other bits I cant remember! Currently 303 bhp @ 4600 revs and 350-360lb torque across a wide rev range. Running far too lean though!

[SILICONEKID346HP]

TV8 said:

Its not a 400. I must change my profile - 5.3 V8Dev, small amount of work on the standard 500 heads and a MC1 cam with a couple of other bits I cant remember! Currently 303 bhp @ 4600 revs and 350-360lb torque across a wide rev range. Running far too lean though!

I heard v8D will sell you the bored 72mm plenum ,45mm trumpet base with short flared aluminium trumpets and the port matched inlet manifold or a very competitive price if you buy the three .

Why not give them a call

[TV8]

SILICONEKID346HP said:

I heard v8D will sell you the bored 72mm plenum ,45mm trumpet base with short flared aluminium trumpets and the port matched inlet manifold or a very competitive price if you buy the three .

Why not give them a call

I have dropped Rob a line and will see what he says. Any suggestions for the injectors please?

[Chuffmeister]

Would something like this not do?
http://www.ebay.co.uk/itm/Bosch-315cc-30lb-Injecto...