Boot won't lock shut
Discussion
Are the two bolts done tight enough? Reason I ask is because mine would not latch due to loose bolts or that's what it seemed. The bolts were not actually loose it was the captive fixings inside the boot lid that had worked loose. I fixed this with a sets like steel epoxy resin squished around the captive nuts and left to set before tightening the bolts back up. Also use spring washers behind the two bolts. My striker plate would move a few mm every time I tried to close the boot which was enough to not allow it to latch. All works good again.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


