Looking for a picture of wires behind dash beside radio.

[Silhouvette]

I am trying to put back together a chimaera for a friend. He replaced the dash a while ago now but didn't note the location of the nest of wires beside radio. I think it's for lights, hazards and all that. Would anybody by chance have a picture of these wires in place, that is of course as long as tvr used the same colours in each car. Otherwise it's going to be quite a tedious job to look forward to. Thanks in advance

[wseed]

On mine it was just ribbon cables going from each switch to a control box I think a slightly wider one to the lights and then just a 5 way one to the hazards and fog lamp switch. it should be easy enough to test them or is this a different configuration?

[J400GED]

Does your dash have buttons similar to this?

[Silhouvette]

Yes that looks the One! Let me take a picture of it and I'll load it up. There is a nest of cables behind.

[Silhouvette]

A pic of the dash as it sits.

[Alpha Omega]

I wish that image was bigger but - It looks like the vehicle has standard British colour coded wiring. I think it is standard British because at the left side where that loom exits in the direction of where the hazard switch is going to be I can see a green/red trace wire and a green/white trace wire and I know those are used for LH/RH indicators in which case this proves to be the hazard switch loom.
All you need do is take a look at a British Colour Codes Chart and all will be revealed for all those wires you need to terminate
Here is one of many around the net - http://www.primauto.net/file_schemi_aggiuntivi/bri...

[Silhouvette]

Alpha Omega said:

I wish that image was bigger but - It looks like the vehicle has standard British colour coded wiring. I think it is standard British because at the left side where that loom exits in the direction of where the hazard switch is going to be I can see a green/red trace wire and a green/white trace wire and I know those are used for LH/RH indicators in which case this proves to be the hazard switch loom.
All you need do is take a look at a British Colour Codes Chart and all will be revealed for all those wires you need to terminate
Here is one of many around the net - http://www.primauto.net/file_schemi_aggiuntivi/bri...

Thanks for that, great help. If you click the picture it should get bigger.

[Alpha Omega]

If it was a big picture you can click the picture and then click the picture that shows for a big picture
No problem, with a little reading and tagging what you work out you should be able to narrow the unknowns down

[Silhouvette]

Alpha Omega said:

If it was a big picture you can click the picture and then click the picture that shows for a big picture
No problem, with a little reading and tagging what you work out you should be able to narrow the unknowns down

Right I get ya. I had to resize the image to load it up. Must of went too small. 😄

[Alpha Omega]

Silhouvette said:

Alpha Omega said:

If it was a big picture you can click the picture and then click the picture that shows for a big picture
No problem, with a little reading and tagging what you work out you should be able to narrow the unknowns down

Right I get ya. I had to resize the image to load it up. Must of went too small. ??

OK if you get stuck post back here