Rear Hub housing maintenance

[FoxTVR430]

Looking for some advise as I am stripping the car at the moment.
I have the rear hub apart but I would like to know if I can just pull the out wheel rotor trough the housing?
The two arrows show the two parts that I would like to split.
Any (helpful) advise welcome.

[BoostedChim]

Not done it myself but yeah that is my understanding too. The hub itself should press out of the bearing carrier and then you can change the rear wheel bearings.

Its Sierra components so try googling "Sierra rear wheel bearing change"

This might help http://www.alfadax.com/content/before/sierra/sierr...

[FoxTVR430]

Great thanks Boosted chim.

[phillpot]

Yep, just tap it out, shouldn't be very tight.

[Sardonicus]

You will only be driving that stub through one inner race if the other is stuck it will just take the oil seal with it IYSWIM so like Phillpot says dont damage the taper or the spines while you drive it out

[Tony91]

There is a good guide here http://nw.rhocar.org/wheel_bearing.htm