Finally finished polishing!!

[Dave85chim]

Just done the manifolds and y-piece.... look good - but struggling to get a better finish on them. I’m guessing with heat through them they will bronze off ok.









All in all pretty happy. Now, I’m hoping to fit these this week. So any tips welcome.

I have new bolts and spring washers. Do they need flat washers also?

I’m thinking of cutting slits into the lower holts so manifolds can slot into the bolts- Any negatives or drawbacks?

All thoughts welcome!!

[Andav469]

They look awesome

My advice would be to get the smaller head bolts and nord locks from ACT, the smaller heads make it a breeze to fit, no slots needed in your manifolds

[Dave85chim]

Cheers Andav!

Sounds like a plan - will take a look now...