TVR Chimaera Air Induction Piping
Discussion
I am considering upgrading the Air Induction Pipes on my TVR Chimaera 400.
Recent posts by someone call Chimshaw 500 shows a picture of a stainless steel or polished alloy piping system to the Air Plenum.
Chimshaw 500 has also provided a parts list to allow this system to be fitted.
However, the parts system does not identify where each pipe section fits and is confusing.
If anyone knows of Chimshaw 500 I would be grateful if he could supply the information as to where each pipe fits to make up the complete system. Picture below:
Would appreciate any assistance.
Recent posts by someone call Chimshaw 500 shows a picture of a stainless steel or polished alloy piping system to the Air Plenum.
Chimshaw 500 has also provided a parts list to allow this system to be fitted.
However, the parts system does not identify where each pipe section fits and is confusing.
If anyone knows of Chimshaw 500 I would be grateful if he could supply the information as to where each pipe fits to make up the complete system. Picture below:
Would appreciate any assistance.
It looks very nice but it’s going to heat soak like a b
d!
I would go for a nice flexible intake hose that you can direct where you like and purchase some foil lined insulation and do the neatest job you can covering it.
Alternatively buy the kit marketed by ACT and instillate that as well.
d! I would go for a nice flexible intake hose that you can direct where you like and purchase some foil lined insulation and do the neatest job you can covering it.
Alternatively buy the kit marketed by ACT and instillate that as well.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff