Oil Pressure help needed
Oil Pressure help needed
Author
Discussion

spid

Original Poster:

381 posts

271 months

Tuesday 9th August 2005
quotequote all
Lost oil pressure, light on at tickover no pressure showing on gauge. Car has done 30000 miles. Oil pump looked worn so replaced, still no pressure. Mains and big ends then replaced still no pressure. Checked rocker shafts for wear look fine. Any ideas?

M@H

11,298 posts

301 months

Tuesday 9th August 2005
quotequote all
...it sounds obvious I know, but the pump is being primed correctly isn't it ?

Bad luck btw

spid

Original Poster:

381 posts

271 months

Tuesday 9th August 2005
quotequote all
Yes has some pressure only 6lbs at tickover

>> Edited by spid on Tuesday 9th August 14:08

GreenV8S

31,017 posts

313 months

Tuesday 9th August 2005
quotequote all
Pressure relief valve stuck open?

Podie

46,649 posts

304 months

Tuesday 9th August 2005
quotequote all
Pressure sender knackered...?

V8 Archie

4,703 posts

277 months

Tuesday 9th August 2005
quotequote all
Podie said:
Pressure sender knackered...?
Just what I was thinking. You are sure that it's the actual pressure that's low and not just the reading on the guage I take it.

jonathant

880 posts

313 months

Tuesday 9th August 2005
quotequote all
I thought that the oil pressure sender and the oil warning light sender (?) are independant? Certainly I was driving around for a while with my gauge reading -5psi at tickover but pressure confirmed OK by the garage. A new sender fixed the under-reading.

All this time the oil warning light stayed OFF.

spid

Original Poster:

381 posts

271 months

Tuesday 9th August 2005
quotequote all
Found it! Last bearing on the cam has fallen out and is just rattling around the cam.

V8 Archie

4,703 posts

277 months

Tuesday 9th August 2005
quotequote all
jonathant said:
I thought that the oil pressure sender and the oil warning light sender (?) are independant? Certainly I was driving around for a while with my gauge reading -5psi at tickover but pressure confirmed OK by the garage. A new sender fixed the under-reading.

All this time the oil warning light stayed OFF.
True, I missed the bit about the light.

Podie

46,649 posts

304 months

Tuesday 9th August 2005
quotequote all
spid said:
Found it! Last bearing on the cam has fallen out and is just rattling around the cam.