Transmission Tunnel Cover
Discussion
Is it easy to remove the transmission tunel cover - the bit that
goes around the handbrake and door opening twiddly knob.
There are a couple of screws at the front into the tunnel
and a couple at the back under the tray. Is there anything
else that is hidden and is is stuck down anywhere.
The door lock button (centre of knob) is acting up and the
handbrake light stays on even when the brake is off. I suspect
dirty contacts or a loose connection in both cases.
goes around the handbrake and door opening twiddly knob.
There are a couple of screws at the front into the tunnel
and a couple at the back under the tray. Is there anything
else that is hidden and is is stuck down anywhere.
The door lock button (centre of knob) is acting up and the
handbrake light stays on even when the brake is off. I suspect
dirty contacts or a loose connection in both cases.
The gear knob unscrews, you will have to screw down the locking sleeve first, and the door opener has an Allen key screw that needs unscrewing to remove it its base. Then to get to the handbrake the center section under the tunnel needs to be removed. Its held in by self tappers and sealant.
I got to the handbrake switch from above but needed the car raised just to help see what was going on. I couldn't see any way of getting at it from below without removing the exhaust. There is a removable panel that gives very limited access - not to be undertaken lightly, especially trying to fix the switch back in again...
>> Edited by chris_chim on Thursday 6th April 20:39
>> Edited by chris_chim on Thursday 6th April 20:39
>> Edited by chris_chim on Thursday 6th April 20:39
>> Edited by chris_chim on Thursday 6th April 20:39
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


