Engine misfires when I steer to the right???
Discussion
Loose HT leads could very well be the thing. My Chim started misfiring under hard acceleration. Then it was constantly lumpy. Gave all the HT leads a good shove on and it was fine again....for a while...until they got loose again...always set off by hard acceleration. Turns out two of the HT leads get loose and then wobble about under strain...
I'm getting some lovely burned fingers from needing to shove 'em back on whilst its hot.
New leads for me soon.
I'm getting some lovely burned fingers from needing to shove 'em back on whilst its hot.
New leads for me soon.
my old sd1 racer did exactly this it was fine under aceleration/braking/turning right etc... as soon as you went into a left hander the damn thing started missing!! turned out to be a dodgy connection on the ignition barrel and as the steering column turned it was just catching the block connector!
chassis 33 said:
The Chim's don't have an intertia switch do they? The fuel pump relay is controlled by the ECU, so if it sees not spark it turns off the fuel pump, hence when you turn the ignition on the pump whirrs for a moment and then stops.
Regards
Iain
Mines got one? Need to remove the glove box pouchy thing and its inside to the left. Always seems to trip if I go round corners a bit quick
and hit a bumpy patch. Dont think this would be causing your problems though.
Pete
chassis 33 said:
The Chim's don't have an intertia switch do they? The fuel pump relay is controlled by the ECU, so if it sees not spark it turns off the fuel pump, hence when you turn the ignition on the pump whirrs for a moment and then stops.
Regards
Iain
Yes the ones that have them do. Hidden behind the passenger side of the dash...
If you have a trolley jack, why not try jacking it up under the RHS with the engine running?
If you can reproduce the fault like this it may be less frustrating than keep driving it down the road to see if you have cured the problem.
Hundreds of broken crankshafts ago, I have a similar thing on a Hillman Imp! It turned out to be a piece of the carbon centre contact had broken off the distributor cap which rolled on RH bends and shorted something on the baseplate out. Probably not this on your Chim, but you have to admit it's a good 'un!
If you can reproduce the fault like this it may be less frustrating than keep driving it down the road to see if you have cured the problem.
Hundreds of broken crankshafts ago, I have a similar thing on a Hillman Imp! It turned out to be a piece of the carbon centre contact had broken off the distributor cap which rolled on RH bends and shorted something on the baseplate out. Probably not this on your Chim, but you have to admit it's a good 'un!
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



