Stalling 4.0 Chim'
Discussion
Any ideas on what to do next. My car keeps stalling for no apparent reason.
I have swapped the airflow meter, stepper motor and throttle potentiometer with a car that doesn't stall and it made no difference. I have replaced the coolent temp sensor that goes to the ECU and the fuel pump relay as well as the throttle potetiometer relay and this seemed to sort it as it would run from cold all the way to hot without stalling. But if i have driven it and pull up to lights etc it starts to "hunt" and eventually dies.................any help would be appreciated.
P.S taking the breather pipe off seems to help the tickover but it still stalls eventually (none of the pipes are blocked)
Help
I have swapped the airflow meter, stepper motor and throttle potentiometer with a car that doesn't stall and it made no difference. I have replaced the coolent temp sensor that goes to the ECU and the fuel pump relay as well as the throttle potetiometer relay and this seemed to sort it as it would run from cold all the way to hot without stalling. But if i have driven it and pull up to lights etc it starts to "hunt" and eventually dies.................any help would be appreciated.
P.S taking the breather pipe off seems to help the tickover but it still stalls eventually (none of the pipes are blocked)
Help
faulty lambda probes even 1 of 2 can create hunting & intermitant cutting out not always obvious,lazy switching voltage,can be erratic,normally followed by strong egg smell from exhausts if there sending ECU rich. when its playing up,just a thought,give it a go,good luck.just check the obvious things first as others suggested.
Edited by That Daddy on Friday 2nd June 22:24
Will check ECU connections, seems to covered in bubble wrap and sitting sideways on the floor instead of on top of the battery as all my other have, so could have got wet.
Did think of Lamda sensors although some mechanics I asked pointed me away from this, but could be worth a try.
TVR Power at coventry suggested new cap and leads.......
Here we go again!
Did think of Lamda sensors although some mechanics I asked pointed me away from this, but could be worth a try.
TVR Power at coventry suggested new cap and leads.......
Here we go again!
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



