Bonnet stay clip... anyone know what it's off?

[pupp]

Mine went walk-about this week whilst the car was in the tender mercies of an indie for an MOT test. I'm assuming it's a generic part. Any ideas?

[siobe]

pupp said:

Mine went walk-about this week whilst the car was in the tender mercies of an indie for an MOT test. I'm assuming it's a generic part. Any ideas?

I'd like to know as well, mines gone a bit limp which leaves my rod flopping about

[Hotwire]

I have seen these clips on the clever trevor webb site part no is UOO69 .
I hope this helps Dave

www.clever-trevor.net

Edited by Hotwire on Saturday 14th October 19:22

[pupp]

Hotwire said:

I have seen these clips on the clever trevor webb site part no is UOO69 .
I hope this helps Dave

www.clever-trevor.net

Edited by Hotwire on Saturday 14th October 19:22

Nearly but not quite (though they might do at a pinch)... the Chimp ones are on posts that push into the inner wing (with retaining legs on). Cheers anyway

[That Daddy]

pupp are you on about the rod stay balljoint, or the end thats secured with the little plastic clip on the inner wing

[pupp]

That Daddy said:

pupp are you on about the rod stay balljoint, or the end thats secured with the little plastic clip on the inner wing

It's the little plastic clip that's pegged into the inner wing

[That Daddy]

dont know where you can get a chim one, but a ford one would work a treat,same size bar,ask a helpful ford storesman to show you what hes got....the clips that is.

[pupp]

That Daddy said:

dont know where you can get a chim one, but a ford one would work a treat,same size bar,ask a helpful ford storesman to show you what hes got....the clips that is.

I've seen some Ford 'self rivet' ones on ebay that look suitable

[That Daddy]

see pup helping you again,he he.but seriously that type maybe just the ticket, if you mean the type with the push centre pin that flares the claws in the hole,then yes yes.

[pupp]

That Daddy said:

see pup helping you again,he he.but seriously that type maybe just the ticket, if you mean the type with the push centre pin that flares the claws in the hole,then yes yes.

That's the fella

[SpeedEight]

Isn't it a landrover part?

[TimmyArt]

the bonnet catch is a Ford Escort according to my manual info..

[siobe]

TimmyArt said:

the bonnet catch is a Ford Escort according to my manual info..

Also in the garage we have a Ford Escort, so I'll have a look under the lid and see if its the same, I don't suppose my wife will miss such a small piece of plastic.