Oil pressure sender
Oil pressure sender
Author
Discussion

-JUT-

Original Poster:

2,258 posts

243 months

Monday 30th April 2007
quotequote all
Intermotor 53800 - is this the part number for an oil pressure sender for a '96 Chimaera 4.0, for the gauge itself not the warning light on the dash? I have some questionable readings on my gauge (around 15 psi when hot) but the warning light does not come on, so I'm thinking the sender might be duff, but not keen on paying about £60 for an original one if I can get the intermotor part for around £20.

spend

12,581 posts

281 months

Monday 30th April 2007
quotequote all
If the light is not working?

Light is actived by std LR oil pressure switch @£5 from any LR indy etc. You can get some combined pressure senders & switches - only needed if you are short of oil gallery tappings - but not in the scope of what you require I think.

Dave

-JUT-

Original Poster:

2,258 posts

243 months

Monday 30th April 2007
quotequote all
Pretty sure the light is working, i.e. it comes on when you turn the ignition on, but goes out once the engine is started. So I'm more inclined to think the gauge is giving an inaccurate reading.

Found out my speedo's just as bad this week - testing indicated speed against GPS, 90 mph indicated is actually 78 mph, but bizarrely 100 mph indicated is 94 mph actual - not on public roads, obviously...

spend

12,581 posts

281 months

Monday 30th April 2007
quotequote all
Pressure switch is very low pressure <10psi IIRC. You should get a garage to use calibrated pressure tester to check your pressure first IMHO.

Dave

-JUT-

Original Poster:

2,258 posts

243 months

Monday 30th April 2007
quotequote all
spend said:
Pressure switch is very low pressure <10psi IIRC. You should get a garage to use calibrated pressure tester to check your pressure first IMHO.

Dave


If the intermotor sender is only about £15-£20, won't it cost more to get a garage to test it than to replace the sender?

That Daddy

19,458 posts

251 months

Monday 30th April 2007
quotequote all
spend said:
Pressure switch is very low pressure <10psi IIRC. You should get a garage to use calibrated pressure tester to check your pressure first IMHO.

Dave

Yes, you may find it is telling fibbs my one does by about 10psi across the range but i just monitor what readings it does give to know its all ok,when i know the true readings are normal,i put it on my oil pressure tester(non electric)and readings i got where 22 hot idle fast idle 42 if i remember.


Edited by That Daddy on Monday 30th April 11:29

spend

12,581 posts

281 months

Monday 30th April 2007
quotequote all
-JUT- said:
If the intermotor sender is only about £15-£20, won't it cost more to get a garage to test it than to replace the sender?

Matching senders & gauges could be described as hit/miss or a black art The knowledge of your actual pressures will be useful if either you replace sender (so you can tell new one is accurate/not) or your pump/oil need attention.

Cant see a garage charging too much for this.

Dave