Replacing gaiter
Discussion
Hi , Sorry if this is answered elsewhere, but I've searched and cannot find the information.
I have an 1993 Chimaera and I've just purchased a new leather gaiter , However upon trying to fit it I cannot find how to release the door control "golf ball " , I've searched the forums and noticed that others have posted saying there is a allen screw located near the base , But I've searched and cannot find one !! .
Can anyone advise how I remove this item ?
I have an 1993 Chimaera and I've just purchased a new leather gaiter , However upon trying to fit it I cannot find how to release the door control "golf ball " , I've searched the forums and noticed that others have posted saying there is a allen screw located near the base , But I've searched and cannot find one !! .
Can anyone advise how I remove this item ?
Hi , Sorry but I cannot find a grub screw ,
I have inspected the Golf ball and even used a dentist's mirror to view it and there is no grub screw anywhere to be seen.
It's a early chimaera if that makes any difference , below the golf ball is a chrome disk around the leather gaiter and below that a 17mm spanner size nut .
Can anyone offer any other advice ??
I have inspected the Golf ball and even used a dentist's mirror to view it and there is no grub screw anywhere to be seen.
It's a early chimaera if that makes any difference , below the golf ball is a chrome disk around the leather gaiter and below that a 17mm spanner size nut .
Can anyone offer any other advice ??
Hi ,
Yes I've tried undoing this nut without much success !
As the existing leather Gaiter is so badly worn it will pull up and over the golf ball , leaving the chrome ring and the nut behind .
Once the centre unit has been removed I can gain access to the nut , I had hoped that by tighting the nut up tight against the ball and then applying pressure to the golf ball it would undo but it didn't work.
I'm at a complete loss and I'm hoping that someone on here will have an answer !
Yes I've tried undoing this nut without much success !
As the existing leather Gaiter is so badly worn it will pull up and over the golf ball , leaving the chrome ring and the nut behind .
Once the centre unit has been removed I can gain access to the nut , I had hoped that by tighting the nut up tight against the ball and then applying pressure to the golf ball it would undo but it didn't work.
I'm at a complete loss and I'm hoping that someone on here will have an answer !
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




