Flat Battery + Charging + Alarm
Flat Battery + Charging + Alarm
Author
Discussion

PetrolTed

Original Poster:

34,468 posts

334 months

Thursday 25th September 2008
quotequote all
We managed to leave the driver's door ajar last time we used the car and now the battery's flat.

As I charge it the alarm is going off. Is there any way to stop that other than disconnecting the battery whilst I charge it?

V8 GRF

7,299 posts

241 months

Thursday 25th September 2008
quotequote all
You need to reset the alarm.

If it's a Meta they gets confused when the battery is re charged after being flattened. Remove the earth from car battery for 5 secs, reconnect then immediately press the alarm plipper. That should sort it.


Edited by V8 GRF on Thursday 25th September 15:17

bam50

218 posts

236 months

Thursday 25th September 2008
quotequote all
Ted, does your siren have a backup battery override key?

Edited by bam50 on Thursday 25th September 15:29

PetrolTed

Original Poster:

34,468 posts

334 months

Thursday 25th September 2008
quotequote all
bam50 said:
Ted, does your siren have a backup battery override key?

Edited by bam50 on Thursday 25th September 15:29
No idea smile

PetrolTed

Original Poster:

34,468 posts

334 months

Thursday 25th September 2008
quotequote all
V8 GRF said:
You need to reset the alarm.

...
Thanks. Will try that.

PetrolTed

Original Poster:

34,468 posts

334 months

Thursday 25th September 2008
quotequote all
I've disconnected the positive and am charging the battery.

Not sure I can get the negative off as the wiring around there is all too tight.

Will the alarm go mental once I reconnect the charged battery?

T_Pot

2,542 posts

228 months

Thursday 25th September 2008
quotequote all
Mine did the same this week, result was i used a booster pack to start the car and that allowed the alarm to be turned off with the fob and didnt sound again.

took it for a short spin to put some charge back into the battery then came back and put charger on it

V8 GRF

7,299 posts

241 months

Thursday 25th September 2008
quotequote all
PetrolTed said:
I've disconnected the positive and am charging the battery.

Not sure I can get the negative off as the wiring around there is all too tight.

Will the alarm go mental once I reconnect the charged battery?
Try doing as I suggested with the positive terminal instead.

PetrolTed

Original Poster:

34,468 posts

334 months

Thursday 25th September 2008
quotequote all
thumbup Will try in the morning.

bam50

218 posts

236 months

Thursday 25th September 2008
quotequote all
PetrolTed said:
bam50 said:
Ted, does your siren have a backup battery override key?

Edited by bam50 on Thursday 25th September 15:29
No idea smile
Ted, have a gander at p23, alarm & locking section, of the owner's handbook. That might help you until the battery is fully charged and you can reset it.

MoreSteam

698 posts

221 months

Friday 26th September 2008
quotequote all
I had the same thing earlier this week. It's an after market alarm I have, but I just pulled the fuse for it. This worked a treat. In the morning, after charging all night, I put the fuse back in. The alarm made a protest but then fell silent. Job done!

Big Al.

69,336 posts

289 months

Friday 26th September 2008
quotequote all
Do you know the emergency way in? hehe

Ted I always point Tivvers and especially new boys like you on the forum, hehe to phone up Carl http://www.tvruk.tv/ Tell him you're from PH and mention who you are, you never know he might even give you a bit of discount! wink

Runs for cover

PetrolTed

Original Poster:

34,468 posts

334 months

Friday 26th September 2008
quotequote all
I had my broom handy thanks smile

All sorted now and just been out for a quick burble in the sun cool

T_Pot

2,542 posts

228 months

Saturday 27th September 2008
quotequote all
how do you get an avatar like yours bigal