Fire extinguisher
Fire extinguisher
Author
Discussion

daf4trucks

Original Poster:

37 posts

254 months

Saturday 3rd January 2009
quotequote all
Hi.
I am looking for advice on fitting an appropriate fire extinguisher within the cabin.
Basically, where is the best fixing point?

Regards.
daf4trucks

lewis_sharman

5,958 posts

222 months

Saturday 3rd January 2009
quotequote all
A lot of people seem to fix them on the rear parcel shelf between the seats. This is where i will be mounting mine i think.

CLN1

657 posts

256 months

Saturday 3rd January 2009
quotequote all
I've fastened mine to the floor behind the drivers seat.

Colin.

spend

12,581 posts

282 months

Saturday 3rd January 2009
quotequote all
Under the front of the seat?, so even if I cant pull it out I can set it off to save my precious Jewels hehe

GreenV8S

31,027 posts

315 months

Saturday 3rd January 2009
quotequote all
Sideways under the front of the driver's seat. So you can reach it while you're seated, and also reach it from outside the car without climbing inside. It's also more or less out of sight from outside in case you ever need to leave the car with the top down.

Andy Pandie

1,165 posts

240 months

Saturday 3rd January 2009
quotequote all
CLN1 said:
I've fastened mine to the floor behind the drivers seat.

Colin.
+1 yes

kenny Chim 4

1,604 posts

289 months

Saturday 3rd January 2009
quotequote all
Peter, that's where it was situated in my previous car but the plastic retainer/holder quickly detatched itself leaving the unit rolling around in the footwell. I then moved it to the compartment behind the seat.

I drive with the seat as far forward as possible so it would have been easy to reach back and grab should the situation arise.

spend

12,581 posts

282 months

Saturday 3rd January 2009
quotequote all
If you have to choose where to ballast your car... keeping the weight as low as possible, and even side to side seems logical to me, ie keeping the CoG as low and close to the c/l as you reasonably can wink

GreenV8S

31,027 posts

315 months

Saturday 3rd January 2009
quotequote all
You should make sure that it has a proper mounting bracket bolted to the floor with large penny washers to spread the load, and proper overcenter straps to hold it into the bracket. The cheap and nasty sprung holders aren't good enough to hold it in place in an accident.

daf4trucks

Original Poster:

37 posts

254 months

Sunday 4th January 2009
quotequote all
Thanks for all the good and varied advice.
I suppose my main concern was employing the old drill, and getting it right first time.

cptsideways

13,895 posts

283 months

Sunday 4th January 2009
quotequote all
Consder you can buy a plumbed in zero 2000 motorsport system for £80, with a passenger & engine bay nozzle. Definately worth thinking about.

Also note that the sprung clips are useless in the event of an accident! make sure you use additional fastnings, I use two fat zip ties to hold mine down, they are the type that can be broken with some leverage if need be though. Alternatice is to use the ss clips but zip tie the clasps down.

lesstatt

4,318 posts

221 months

Sunday 4th January 2009
quotequote all
Hmmmmmmm mine is in the boot velcroed near the petrol filler on a flat part, couldnt see anywhere in the cabin suitable really and it only takes a few secs to get to the boot, i know thats not ideal if you are upside down and covered in petrol but its better than not having one at all