Pre serp sump replacement - gasket or not?
Pre serp sump replacement - gasket or not?
Author
Discussion

Barkychoc

Original Poster:

7,848 posts

235 months

Monday 12th January 2009
quotequote all
I'm going to be rebuilding my V8S engine over the next month or so - I'm pretty clear on most of it apart from sealing the sump.
I've read a few threads on not bothering with a sump gasket and using a VW spec sealant.

Whats the general view?

Is the reality that its down to personal preference?

I assume there is no rubber sump gasket available like the serp one?
(and if there is would you use it?)

Cheers

V8 Animal

6,015 posts

241 months

Monday 12th January 2009
quotequote all
I used instant gasket on my serp engine sump a year ago and still dry.

VerySideways

10,272 posts

303 months

Monday 12th January 2009
quotequote all
I used a cork gasket on my pre-serp 4.0 - that and the Steve Heath sump plug and all my leaks diappeared...

spend

12,581 posts

282 months

Monday 12th January 2009
quotequote all
Seems its hard to get hold of the 'good' thicker cork gaskets which many swear by, I just vaseline them others tack them on - but keeping them in place whilst sealing is critical. Others have reported 'bits of cork' in the sump! wink but they also get that with the silicone version. Many smear the silicone and leave it overnight to tack before mating.. heard lots of methods. I suspect a lot of experiences could be related to the state of the sump, dings on the road and using it to jack up the engine whilst changing mounts the most obvious, I'd check for a 'flat' surface whilst it is off wink

I have another completely different way, which has been successful for me, but if I told you about it I'd have to kill you hehe

Barkychoc

Original Poster:

7,848 posts

235 months

Monday 12th January 2009
quotequote all
So to add to the mix then there are different thicknesses of cork gasket?eek

I've got part of a bottom end gasket set that I've had kicking around for ages and the cork gasket in that isn't very thick - so I assume its one of the thinner ones?

What about just using Hermetite blue or something?
I assume you have to be careful so it doesn't end up in the sump if you put too much on.

VerySideways

10,272 posts

303 months

Monday 12th January 2009
quotequote all
Mine wasn't overly thick - ebay, about £15 IIRC.

http://www.verysideways.com/pages/g33_sump.htm

K4TRV

1,819 posts

283 months

Monday 12th January 2009
quotequote all
VerySideways said:
I used a cork gasket on my pre-serp 4.0 - that and the Steve Heath sump plug and all my leaks diappeared...
+1.....and me