Graunchy crunchy driveline noise.... guess the cause
Discussion
Just limped home with said graunchy crunchy noise, and very slight occasional vibration (as something was obviously breaking up), after just one sharp bang after pulling from a junction. Nothing visible on the roadside, car still driving (sloooooooowly and smoooooooothly as not too far from home) with no obvious loss of fluids, drive or overheating of anything.... Seemed to be from rear drivers side
...I'm guessing driveshaft CV joint(s). Any others...? Prolly be tomorrow before I get chance to investigate properly so all suggestions welcome (within reason)
Oh, while I'm at it, big thanks the to numerous impatient idiots on the A6116 who were tailgating an obviously sick car displaying hazards when there was loads of time/space to just overtake...
...I'm guessing driveshaft CV joint(s). Any others...? Prolly be tomorrow before I get chance to investigate properly so all suggestions welcome (within reason)
Oh, while I'm at it, big thanks the to numerous impatient idiots on the A6116 who were tailgating an obviously sick car displaying hazards when there was loads of time/space to just overtake...

Edited by Pupp on Friday 16th January 13:28
I would guess driveshaft CV or diff, prop I would have thought would snap a joint or be too bad to drive at all once gone ping.
Tailgaters
don't get me started. It's amazing how many drivers there are out there who don't know how to overtake but think it's OK to stop everyone else doing it by driving right up one's chuff!!
Tailgaters
don't get me started. It's amazing how many drivers there are out there who don't know how to overtake but think it's OK to stop everyone else doing it by driving right up one's chuff!!spend said:
Diff calamity sounds just like that IME 
Cheers!
Hopefully not, was a fair bit of 'clicketty click' going on too and I've never heard a diff do that. But you never know.
I'm assuming the wishbones have to come out or at least be dropped/swung somehow to get the shaft out? Anyone able to point me to a walk-through anywhere please? Might as well gen up and then find it's the diff...

First 1 degree on each cap head is most critical, you then quickly learn to loosen off in sequence with a ball end so the d/s doesn't fall off & you cant access the last one
If I explained it you'd do different - it becomes apparent when you struggle. IIRC I found it easier to remove the wheel end with the wheel loaded, then support the shaft in a cup to do the diff end, adjust the holder to get the angle you need for best access (but you know me & my inexhaustible supply of scrap wood
)
If I explained it you'd do different - it becomes apparent when you struggle. IIRC I found it easier to remove the wheel end with the wheel loaded, then support the shaft in a cup to do the diff end, adjust the holder to get the angle you need for best access (but you know me & my inexhaustible supply of scrap wood
)spend said:
Avoiding FRUSTRATION
is key when working in those awkward places, its definitely a pack of fags each side job in my b;ack book of estimating metrics 
know all about that, it's just taken me all day to get the rear copper brake pipes off, reflared, and on again. If I smoked it would have been 3 packs
is key when working in those awkward places, its definitely a pack of fags each side job in my b;ack book of estimating metrics 

good luck with the graunch!
From Steves cue it is well worth the time whilst you are down there to study the effects of ride height on your driveshaft alignment. It's quite easy to see how much extra stress is put on the joints at small deflections. The next time you see an inordinately low car you will then be wondering how long their D/s will last 

Gassing Station | Chimaera | Top of Page | What's New | My Stuff



